Date post: | 27-Jul-2018 |
Category: |
Documents |
Upload: | truonghanh |
View: | 258 times |
Download: | 10 times |
INTRODUCTIONXPROG-m Errata Sheet 001
This errata provides information applicable to the following products:● 1-002-0017 programming adapter Rev.B or earlier
These changes allow you to work with secured ARM MCU via JTAG interface
STEP1
Remove this resistor
STEP2
● Prepare the four wires. About 5cm in length.
1A
2A
3A
4A
1B
2B
3B
4B
1A
3A
2A 4A
STEP3
● Solder wire shown in the corresponding points at the bottom side
2B
3B
4B1B
STEP4
● Solder wire shown in the corresponding points at the top side
© 2009 TMT
www.uobd2.com
E-Mail:[email protected] MSN:[email protected] Tel:0086-13986168065 SKYPE:greebid6
www.uobd2.com
www.uobd2.com