LEHUI KGFELECTRO-PNEUMATIC FILLER
The LEHUI KGF Electro-Pneumatic filler is a new generation LEHUI filler. This new filler combines the robust mechanical design with the flexibility of EP technology.
LEHUI KGF ELECTRO-PNEUMATIC FILLER
FILLING PROCESS
NANJING LEHUI LIGHT INDUSTRY EQUIPMENT CO.,LTD.Add: No.600 Jiangjun South Rd, Jiangning Dist, Nanjing, 211151 Jiangsu P.R.ChinaTel.+86-(0)25-52733666 Fax.+86-(0)25-52733681E.mail: [email protected]
We are looking for local service partner globally and regional
agency worldwide.Please contact:
Seeking agents worldwide
The filling process is performed with the container pressed against the
filling valve by lifting cylinder. A single or double pre-evacuation is
used depending on the product.
Victor Fu, [email protected]/+86 138 1391 8809 Erik Van Noort, [email protected]/+32 486 55 61 86
The CIP is performed in a closed circuit, which enables a thorough
cleaning of all internal parts of the filling system. Moreover, both the
internal and external design meet the sanitary requirements, with
no dead angle. Such design guarantees that the whole machine
can be totally covered and sterilized by foaming system, which
conforms to the draft beer filling standard.
The system makes multiple pre-evacuation possible with low
oxygen pick-up less than 20 ppb.
Filling accuracy is ensured even while the filler running at a low
speed, which is impossible by mechanical filler.
With much lower CO2 consumption compared with mechanical
filling valves.
With much higher reliability due to fewer mechanical parts.
With lower operating cost due to less wear and tear parts.
Be applicable to filling of wide range of products such as beer,
carbonated soft drinks or non-carbonated soft drinks.
FEATURES
When the pressure inside container equals
to the backpressure of the ring bowl, filling
starts. The filling height is determined by
vent tube. When the product is filled up to
the vent tube, filling stops. All these make
the filling process smooth and complete.
The vent tube is changeable according to
different container or products. The ring
bowl, centring bell, lifting cam and capping
system are equipped with automatic height adjustment with memory
function.
All filling process steps can be programmed easily and individually,
which is optimized specifically to the respective combination of
product and container.
