Date post: | 14-Jan-2016 |
Category: |
Documents |
Upload: | edgar-beales |
View: | 219 times |
Download: | 0 times |
03 Dec 2002CMS Week - Bonding WGSalvatore Costa - Catania
Status Report on Status Report on BondingBonding at at CataniaCatania
Salvatore Costa
University and INFN – Catania
03 Dec 2002CMS Week - Bonding WG 2 Salvatore Costa - Catania
Real Module Bonding
The first real module bonded in Catania was bonded early August 2002, just before our clean room was shut down for transfer to new Department Building.
It is a TIB module with two 512-strip old CSEM sensors.
Loop height of 150 (m or .1 mil ?) was used (too low for current thinking).
03 Dec 2002CMS Week - Bonding WG 3 Salvatore Costa - Catania
Test of Real Module Bonded
Could not read module in Catania. Being the CMS-like system setup in Catania also relatively recent, we weren’t sure whether problem had been introduced by Bonding or was in Test system. Brought Module to Florence were a test setup was in operation.
Enrico Scarlini (who our technician Nunzio Giudice learns from, besides learning from Paolo Tempesta) judged all readout bonds good and correctly done (although with insufficient loop height for the current prescription), and all bias bonds also correct except for one from the bias ring to a HV capacitor pad.
The bad bias bond had to be redone and after redoing the Module was successfully read in Florence.
03 Dec 2002CMS Week - Bonding WG 4 Salvatore Costa - Catania
The Bad Bias Bonds
03 Dec 2002CMS Week - Bonding WG 5 Salvatore Costa - Catania
Explanation from our Florence colleagues…
Due to insufficient loop height, a likely flexing of the Module may have caused the bond wire to touch the p+-implanted line, which thus went to same voltage as the back of the Si, i.e. HV. This effectively shorted ground and back together.
So, as soon as powered, Module drew maximum current. High current burnt tiny contact surface between wire and
silicon and spawned oxide formation on the bond foot. This prevented further correct biasing of the Module even
though after moving the Module around, wire would no longer touch p+-implanted line.
03 Dec 2002CMS Week - Bonding WG 6 Salvatore Costa - Catania
Test Results before Bonding
• Noise (by ARC) • Calibration (by ARC)
03 Dec 2002CMS Week - Bonding WG 7 Salvatore Costa - Catania
Test Results after Bonding(by CMS-like)
03 Dec 2002CMS Week - Bonding WG 8 Salvatore Costa - Catania
Cold Boxes
Catania is in fact producing Cold Boxes for all INFN bonding CentersBoxes produced and distributed: 4
(at Catania, Bari, Firenze, Pisa)Boxes under construction: 2
(for Padova and Torino)
03 Dec 2002CMS Week - Bonding WG 9 Salvatore Costa - Catania
Test Systems
CMS-like is fully operational, as has been for a while already
ARC installed butStruggled for some time to make it work until a
hardware problem was found in a cardProblem repaired, ARC has been tested to the
extent that this is possible without connecting it to anything internally working
Next week I will organize a real Module readout with ARC
03 Dec 2002CMS Week - Bonding WGSalvatore Costa - Catania
…break…
03 Dec 2002CMS Week - Bonding WGSalvatore Costa - Catania
DataBase Interface DataBase Interface UpdateUpdate
Salvatore Costa
University and INFN – Catania
03 Dec 2002CMS Week - Bonding WG 12 Salvatore Costa - Catania
Interface Dev Status
Little progress since last Mtg, Oct 22, due to teaching duties Will resume working on it from Dec 10 and still hope to
deliver full, talking to TrackerDB, v. 1.0 around Christmas A.Profeti has started inserting from Pisa Pull Test data even
as v.0.2 does not yet transmit such data to TrackerDB. I’ve begun saving and regualarly backing up evry night inserted data for later shipping to TrackerDB
Played with Relay Appl to query TrackerDB from within my Perl scripts and it woks indeed
Got some suggestions on rearrangement of present variables among Tables
Still waiting for written description of some more useful variables to add
03 Dec 2002CMS Week - Bonding WG 13 Salvatore Costa - Catania
Center “DB Readiness”
Center DB Responsible Form Defaults
Aachen Wolfgang Braunschweig MISSING
Bari Valeria Radicci OK
Catania Salvatore Costa OK
CERN Alan Honma OK
FNAL Bill Kahl OK
Firenze Simone Paoletti OK
Karlsruhe Hans-Jürgen Simonis OK
Padova Maurizio Loreti IN PROGRESS
Pisa Andrey Starodoumov IN PROGRESS
Santa Barbara Bill Kahl OK
Strasbourg Pierre Juillot OK
Torino Ernesto Migliore OK
Vienna Thomas Bergauer OK
Zurigo Klaus Freudenreich OK