11

KPS Leak Detection

No maintenance and perfect for retro-fit

2

KPS Leak Detection – KP 315

What is the worst enemy of service stations ?Leakages

Water entry in tanks

What is the best solution against these threats :

Leak detection system

3

KPS Leak Detection – KP 315

How it works : with double wall piping installation

4

Connections to the piping

The leak detection unit is placed at the lowest point of the piping system, one in each tank sump

Polyamide tubing connects from secondary containment of the piping to the leak detection unit

The manifold is used to connect to multiple pipes

If primary pipe is leaking, fuel will flow by gravity down to the leak detection unit

5

The Leak Detection Unit

A sensor inside the unit reacts to the presence of fluids• Fuel of any sort = leakage from primary pipe to secondary• Water = leaking secondary containment

Proximity Capacitive sensor

6

KPS Leak Detection – KP 315

Non-maintenance No pressure/vaccum Easy integration with tank

gauging systems

7

The Leak Detection Unit

Example of installed leak detection box : retrofit

8

The Alarm Unit

Test buttons Status LEDPower supply

AlarmMute Sensorsconnections

Module : Isolated switch amplifiers

Intrinsic safelyEExi

Power supply Fuses, and relay

9

Applications: Stand-alone

Local installation with audio and visual alarm

Up to 5 pipes connected to each leak detection unit• To monitor up to 9 pipes, add

an extra manifold Up to 6 sumps monitored by

one alarm unit. For more, a extra unit can be added

10

Applications: Telematic Surveillance

The alarm unit is prepared for GSM connection

GSM module

Backofficeserver

Filling station leak detection

Notification and surveillance

11

Applications: Connected to ATG systems

Connect to tank gauging systems or other external monitoring systems via the outgoing signal relay

NO/NC – potential free switch with breaking or closing function : STOP the submerged pumps system for instance

12

Advantages of KP 315 Leak Detection System

Immediate alarm as soon as liquid reaches the sensor - No minimum leak rate or volume

Any leakage is contained by the system and will not contaminate the sump (compare with Veeder-Root containment sump sensors)

No restrictions on pipe volume Works for all secondary contained pipes (steel, fibreglass, flexible)

Quick reset in case of alarm• Disconnect the tubing, empty the container and connect tubing again• Ready to go! No drying times or recalibration of systems.

Easy to install• One cable from the sump to the alarm unit/building• Suitable for retro-fit applications

13

Approval

Approved to EN 13160 – Leak Detection Systems

14

Suggested Positioning

As an add-on to OPW SiteSentinel As an add-on to existing Veeder-Root systems For retro-fit where leak detection is missing Stand-alone as a low investment solution Where low/no maintenance costs are required

15

Thank you!