OBD HOSTPOWER BT
OBD HOSTPOWER BT
'Connect'button
Android Quick Start GuideOBDLink MX Bluetooth
Android
Scan the QR code or visit the URL from your Android device to download the OBDLink app:
obdlink.mx/app
Download & install OBDLink app
The DLC is usually found on the driver’s side, under the dash.
– Can’t � nd your DLC? Visit dlc-locator.com
‘POWER’ LED will turn ON, and the ‘BT’ LED will start � ashing slowly.
You must complete steps 7, 8, and 9 within 2 minutes. If you need more time, press the button again.
Attention!
The ‘BT’ LED will switch to a fast blink.
Tap ‘Scan’ if OBDLink MX does not show in Avail-able devices.
– LEDs are o� ? Check vehicle for blown fuses.
[instructions continue on reverse]
Plug MX Bluetooth into the diagnostic link connector (DLC)
Turn ignition to Key On, Engine O� position
Open ‘Settings’ app, and enable ‘Bluetooth’
Press the ‘Connect’ button on MX
Tap ‘OBDLink MX’ to pair the deviceTap ‘Bluetooth - Pair with a device’
Wait for OBDLink MX to appear on the ‘Available devices’ list1
2
3
4
6
85
7
Thank you for your purchase!
If you like OBDLink MX Bluetooth,please post your review on
OBD HOSTPOWER BT
10 Launch the OBDLink app, and tap ‘Connect’
11
12
Choose ‘Bluetooth’
Choose ‘OBDLink MX’
– Need help? Go to obdlink.com/support or scan the QR code
– For advanced configurations, go to obdlink.com/setupor scan the QR code
Once the app establishes a connection with MX, the ‘BT’ LED will turn on solid. Tap ‘Diagnostics’ to start a scan.
MX will now appear as ‘Paired’:
Tap ‘OK’ in the ‘Bluetooth pairing request’ dialog9