PETROLEUM CARGO LOSSES PREVENTION DURING SHIPMENTS
CAPT. IRAWAN ALWI FIIMS.,MNI.,MBA.IIMS conference, Singapore, 18 November, 2010
www.oceanwise-indonesia.com
OIL LOSS
DIFFERENCES/ CHANGE
IN
QUALITY & QUANTITY
QUALITY DETERIORATION(Degradation, Contamination etc
QUANTITY DIFFERENCESR1,R2, R3,R4
PHYSICAL LOSS
(real loss, actually happen)
APPARENT LOSS
(spurious loss/on paper only)
POTENTIAL FACTORS:1. Evaporation ( MINIMAL)
2. Leakage or spillage
3. Slopping
4. Quality degradation or
contamination
5. Crime, etc
POTENTIAL FACTORS:1. Inaccurate calibration: (expired, deformation, etc)
- tanks (shore & ship),meter prover
2. Inaccurate measurement:
- temperature, gauging, water, sludge, clingage detection
- rolling & pitching
2. Inaccurate sampling:
- method, equipment, position, etc
2. Inaccurate laboratory analysis/determination:
- density,
exam
ine
d
OIL CARGO LOSS BASIC CONCEPT
exam
ine
d
DESCRIPTION OF CARGO LOSS
A. PHYSICAL OR ACTUAL LOSS:- is a type of cargo loss that physically or actually occurs during the subjected process.
- Example: evaporation, leakage, slopping, pilferage,contamination, spillage etc.
B. APPARENT OR SPURIOUS LOSS:- is a type of cargo loss that it is seen on the document,but physically does not occur.
- Example: inaccurate B/L, Certificate of quality, Ullagereport etc.
ONE OF THE MAIN SURVEYORS JOB IS CARGO LOSSES PREVENTION..
max. 0.5%
max. 0.2% VEF analysis: Students table for 95% confidence limit Stable & consistent accurate
max. 0.5%
SHORE TANKS
Loading Losses: Transportation Losses: Discharging Losses:
FACTORS OF APPARENT LOSSES: 1. Inaccurate calibration:
Shore tanks Vessel
2. Inaccurate measurement Temperature Ullaging/gauging due to:
- Pitching & rolling - Undetectable free water - Sludge or un-pump able
materials (hard) Free water detection
3. Sampling & analysis (density, %BS&W) 4. Using different tables 5. Improper filling of shore lines
FACTORS OF PHYSICAL LOSSES: 1. Evaporation 2. Spillage or leakage 3. Slopping 4. Crime
FACTORS OF APPARENT LOSSES: 1. Inaccurate calibration:
Vessel Shore tanks Weigh bridges
2. Inaccurate measurement: Temperature Ullaging / gauging
3. Using different Density 4. Sampling & analysis (density) 5. Improper filling of shorelines
SHORE TANK
B/L (R2 or diff of 2-3) (R1 or diff of 1-2) (R3 or diff of 3-4)
Supply Losses (R4 or diff of 1-4)
max. 0.5%
Negligible
Sampling MP
1 2 3 4
VEF analysis VEF analysis
GENERAL ACCEPTABLE LIMITS OF CARGO DISCREPANCIES IN QUANTITY
SHORE TANK
Loading Losses: Transportation Losses: Discharging Losses:
FACTORS AFFECTING APPARENT LOSSES: QUANTITY: 1. Inaccurate calibration tables:
Weighbridge Shore tanks Vessels tank
2. Inaccurate measurement Temperature Sounding/Ullaging due to:
- Rolling & Pitching - Overtrimmed or overlisted - Undetectable free water - Sludge or unpumpable materials - Accuracy of sounding/ullaging device
3. Sampling & Analysis 4. Improper filling or displacement of the shore lines QUALITY: 1. Sampling (method, position & temperature) 2. Sample compositing 3. Analysis
FACTORS AFFECTING PHYSICAL LOSSES: QUANTITY: 1. Spillage or Leakage 2. Slopping 3. Pilferage QUALITY: Contamination due to: Spontaneous hydrolysis by moisture or free water Hydrolysis by water or sea water entrainment Reaction with the residue of the last cargoes Reaction with coating, tank or interior materials. Steam leaking (Heating system)
SHORE TANK
B/L (R2 or diff of 2-3)
max. 0.2%
(R1 or diff of 1-2)
max. 0.5%
(R3 or diff of 3-4)
max. 0.5%
1 2 3 4
Supply Losses (R4 or diff of 1-4)
max. 0.5%
RATIO OF CARGO LOSS
R1 = loading loss = B/L Qty loaded x 100%B/L
R2 = transportation loss = SFAL SFBD x 100% B/L
R3 = discharging loss = Qty recd Qty dischd x 100%B/L
R4 = supply loss = B/L Qty recd x 100%B/L
Legends:B/L = Bill of LadingSFAL = ships figure after loadingSFBD = ships figure before discharging
BASIC CONCEPT OF CARGO LOSSES VS. INCO TERMS
FOB. CONTRACT, WHERE SHOULD THE CLAIM LODGE ?
IS APPARENT LOSSES CLAIMABLE ?
OPEN DISCUSSION.
RECORD ON CLAIM OF CARGO LOSS
1. Majority of claim on cargo loss are apparent cargo loss that discrepancy between shore and ship sides or delivery and outturn figures are more than 0.5%.This case cannot be accepted, since there is no evident that is physical loss.
2. The standard pleading for cargo loss in the past, 0.5% could not be applied no longer. Now this limit should be stipulated in the sale contract or charter party. This figure is never accepted by USA & other countries.
SHIPBOARD QUANTITY DETERMINATIONENVIRONTMENTCONDITION
CHARACT. OFCARGO
TEMP. DRAFT / TRIM GAUGING LIST FWDETECTION
TRIMCORRT
LISTCORRTMEASUREMENT
& READING
SAMPLING
LAB. ANALYSIS
ASTM, API, IPTABLES
OLD & NEW
DENSITY 15(API GRAVITY,
REL. DENS)
WCF
VCF
CORRECTEDGAUGE
TOV
GOV
NSV
GSV
NET WEIGHT
% S&W
VOLFW
SHIPSTANK CALIBR
TABLES
ENVIRONTMENTCONDITION
Note :
Trim & List Corrections shall be deleted for shore quantity determination
Note :
Trim & List Corrections shall be deleted for shore quantity determination
ANTICIPATING Pilverage ?
HOW TO CONTROLSHIP-SHORE QUANTITY DISCREPANCY
ACTIONS TO BE TAKEN (when the discrepancy exceeds the allowance)
Reconcile all calculations: Recheck volumetric extraction from tank calibration table Check SG or Density adopted
Blow the ships pipeline before regauging
Action to be taken.
Check gauging tape & thermometer used
Regauge all ships tanks and recheck:
The tank reference height Compare with initial gauging Compare with B/L quantity (for significant variance)
Apply VEF (Vessel Experience Factor)
If discrepancy exceeds 0.5%, lodge a Notice of Protest against the vessel
CARGO RECONCILIATION
1. IF THE DISCREPANCY BETWEEN SHORE AND SHIP FIGURES EXCEEDS THE ACCEPTABLE/ ALLOWABLE LIMIT, CHECK
SHORE & SHIP FIGURES CALCULATION.
2. ENSURE THE LINE IS FULL OR EMPTY.
3. REGAUGE SHORE & SHIP SIDES, INCL. TEMPERATURE, FW,SUITABILITY OF THE MEASURING DEVICES USED, REF.HEIGHT ETC.
4. ENSURING THAT THERE IS NO MISFLOW/ MISLOADED/ MISDISCHARGED:- CHECK COFFERDAM, DEEP TANK, BALLAST TANK, FOREPEAK, BUNKER AND OTHER HIDEN SPACES.
Continued
- CHECK DATA OF INITIAL & FINAL QUANTITY OF BUNKER ANDFUEL CONSUMPTION OF THE VESSEL.
- CHECK OBQ OR ROB AND RESIDUAL CARGO REMAINING ON BOARD OR AT THE SHORE/ STORAGE TANK(S) WHETHERANY CLINGANGE, SEDIMENT, SLUDGE OR OTHERUNPUMPABLE MATERIALS ?
5. ANALYSE DIFFERENCE OF FIGURES PER SEGMENT AND QUANTITY COMPONENT.- CHECK THE CORRESPONDING COMPONENT PER SEGMENT.- CHECK PETROLEUM TABLE APPLIED, DENSITY, % S & W,TEMPERATURE, SEA CONDITION, VEF ETC.
WHAT IT CAUSE ??
MOSTLY ARE APPARENT LOSES. COVERING : - HUMAN ERRORS - EQUIPMENTS ERRORS - WEATHER PROBLEMS - DIFFERENT METHODS/TABLE USE - TANKS CALIBRATION ?? - SLUDGES ?
APPARENT LOSS IN QUANTITY
A. CAUSES :
- INACCURATE GAUGING & TEMP. MEASUREMENT ( method,equipment, condition, skill etc )
- INACCURATE CALIBRATION OF SHIP, SHORE TANKS ANDFLOWMETER.
- DISTURBED CONDITIONS ( cargo properties, surroundings,vessel position & stability etc )
- INACCURATE SAMPLING & ANLYSIS
- DIFFERENT OR INACCURATE TABLE USED & INACCURATE CALCULATION.
Continued
B. PROTECTIVE & PREVENTIVE ACTIONS:
- ACCURATE GAUGING & TEMP. MEASUREMENT.
- ACCURATE SAMPLING & ANALYSIS
- SAME TABLE & METHOD OF CALCULATION.
- MINIMIZE CONDITION DISTURBANCE.
APPARENT LOSS IN QUALITY
A. CAUSES:
- INACCURATE SAMPLING ( method, equipment, sampling point, sample preparation etc ).
- INACCURATE ANALYSIS ( method, equipment, preparation,calculation etc ).
B. PROTECTIVE & PREVENTIVE ACTIONS:
- ACCURATE SAMPLING & SAMPLE PREPARATION.- ACCURATE ANALYSIS
PHYSICAL LOSS IN QUANTITY
A. CAUSE:
- EVAPORATION, SPILLAGE, SLOPPING, LEAKAGE, PILFERAGE ETC.
B. PROTECTIVE & PREVENTIVE ACTION:
- INERT GAS INJECTION/ BLANKETING, FLOATING ROOFSTORAGE, VAPOUR RECOVERY SYSTEM, SKILL & MORALEIMPROVEMENT, SECURITY, CRUDE OIL WASHING ETC
PHYSICAL LOSS IN QUALITY
A. CAUSE:
- CONTAMINATION, QUALITY DETERIORATION, ON FIRE/ EXPLOSION ETC.
B. PROTECTIVE & PREVENTIVE ACTION:
- CLEAN & DRY COMPARTMENT WITH SUITABLE MATERIAL,- TANK CLEANING, GASING UP, INERTING, N2 BLANKETING
COC. FOR SURVEYORS(NATIONAL CERTIFICATION)
1. CERTIFICATE OF COMPETENCY FOR EDIBLE/PALM OIL SURVEYOR. 2. CERTIFICATE OF COMPETENCY FOR DRAUGHT SURVEYOR. 3. CERTIFICATE OF COMPETENCY FOR PETROLEUM CARGO
SURVEYOR. 4. CERTIFICATE OF COMPETENCY FOR BULK COAL AND MINERAL
CARGO SURVEYOR. 5. CERTIFICATE OF COMPETENCY FOR LPG/ LNG CARGO SURVEYOR. 6. CERTIFICATE OF COMPETENCY FOR CONTAINER CARGO SURVEYOR. 7. CERTIFICATE OF COMPETENCY FOR IMDG./DANGEROUS CARGO
SURVEYOR. 8. CERTIFICATE OF COMPETENCY FOR REFRIGERATED CARGO
SURVEYOR. 9. CERTIFICATE OF COMPETENCY FOR HEAVY LIFT CARGO
SURVEYOR. 10. CERTIFICATE OF COMPETENCY FOR BULK CHEMICAL CARGO
SURVEYOR.
DIPLOMAS FOR SURVEYORS.(INTERNATIONAL CERTIFICATION)
SEE BROCHURES..
S C C E S S
THERE WILL BE No Success without UWe need your supports
See you in Bali Next IIMS conference, Sept. 2011