Acceptable & unacceptable of cup shape over

IBE.

Prepared by CQA-HK Nov 2012

Triumph

Steps in producing acceptable overall cup

appearance:

1. Accurate cut work both lining and outer cup.

2. No minus tolerance is allowed.

3. Correct seam allowance.

4. Tight stitch tension is not allowed.

5. No over pulling while tacking cup operation.

6. No cutting off excessive material unnecessary.

7. Slight looseness is better, it will disappear after Re. cup. Suggest PC to make a

trail to confirm acceptable amount of looseness.

8. Keep reference sample as Standard for sewing and staffs to follow.

9. Any discrepancy found, pls. contact HK concerned department.

Important note: Failed to follow above will lead to customer complain,

fitting issue & claim.

Triumph 330/11/2012 Title, Author

Acceptable cup shape over IBE ( Left cup )

Triumph

Acceptable cup shape over IBE ( Right cup )

Triumph

Unacceptable cup shape over IBE, cup is tight

and turning outward.

Triumph

Unacceptable cup shape over IBE, cup is tight

and turning outward.

Triumph

Cup lining set back i.o same level with cup pad

edge.

Triumph

Unacceptable outer cup, is smaller than

pattern.

Triumph

Triumph

Unacceptable cut lining and outer fabric, is

smaller than pattern.