S-
Inputs
S-
Outputs
Ground ID at 29.289/29.307 mm Run-out to OD 0.006 mm Taper,
roundness, & straightness
of 0.001 mm
Audit for ID
Step 4: List Key Inputs and
FMEA
MSA
DOE
SPC
Good DRY coverage V.C. Ctwt distribution Moisture
Pressure Filters
Adhesive to die CR2
Speed Temperature Silicone coverage die settings ⇑ Back up roll die
settings
Temp profile Inert gas flow Nozzle velocities Oven settings
Pressure Filters
Steam Pressure Air temp differential speed Roll Pressure ⇑ Face
Moisture
Rolls of good product
Coating Drying1st Filtration Rehumidification