21
U.S. Department of Transportation Federal Aviation Administration Subject: FAA SPECIFICATION FOR L-823 Date: 9/30/08 AC No.: 150/5345-26D PLUG AND RECEPTACLE, CABLE CONNECTORS Initiated by: AAS-100 Change: 1. PURPOSE. This advisory circular (AC) contains the specification for plug and receptacle (cable connectors) used with underground power cables, isolation transformer leads, and light fixture leads for airport lighting systems. 2. EFFECTIVE DATE. Effective six months after the issue date of this AC, only that equipment qualified per the specifications herein will be listed per AC 150/5345-53, Airport Lighting Equipment Certification Program. 3. CANCELLATION. AC 150/5345-26C, FAA Speci fication for L-823 Plug and Recept acle, Cable Connectors, dated April 17, 2000, is canceled. 4. APPLICATION. The Federal Aviation Administration (FAA) recommends the guidance and specifications in this Advi sory Circular for Plug and Receptacle, Cable Connectors. In general, use of this AC is not mandatory. However, use of this AC is mandatory for all projects funded with federal grant monies through the Airport Improvement Program (AIP) and with revenue from the Passenger Facility Charges (PFC) Program. See Grant Assistance No. 34, “Policies, Standards, and Specifications,” and PFC Assurance No.9, “Standards and Specifications.” 5. PRINCIPAL CHANGES. The changes in this AC includ e the following : a. Update drawing s to .DWG format. All dimens ions remain the same. b. Sources for referenced documents are up dated. c. Shall statements are updated to “must” statement s. d. Paragraph 3.3.2 is updated to clarify requi rements for the calculation o f tensile strength of the conductor. e. Paragraph 4.2.1 is rewo rded to clarify pas s/fail criteria. f. Paragraph 4.2.6 now references Section 12 00.15 vice 1200.9 of UL-1581 t o better address the current edition of the UL standard. g. Paragraph 5.1 is updated to correct the insulation resistance val ue to 75,000 megohms. 6. METRIC UNITS. To promote an orderly transition to metric units, this specification includes both English and metric dimensions. The metric conversions may not be exact metric equivalents, and until there is an official changeover to the metric system, the English dimensions will govern. 7. COMMENTS OR SUGGESTIONS for improvements to this AC should be sent to:
