Fab academy 2012

CLASS 15:Machine Design Wed (May 2) STUDENT: WALTER HECTOR GONZALES ARNAO

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy

CLASS 15: Machine Design Wed (May 2) UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

summary design or modify a machine document the group project and your individual contribution make the passive parts and operate it manually

Fab academy

CLASS 15: Machine Design Wed (May 2) UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Summary machine assembled 1-The assignmente for this week is to automate the machine assembled two weeks ago 2-MISSING PARTS OF THE MACHINE 3-Stepper motor driver, so as was impossible to get it locally 4-Roberto, Roxana and Alejandro are making the connections of each H bridge board to each stepper motor and test the Switching PS 5-For complete the assembling we connect the Arduino to the notebook and to each board. the machine ready to be operated in automate mode. installed the software, was necesary modify controlling the new boards 6- work is being completed

Fab academy

CLASS 15: Machine Design Wed (May 2) UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Summary project loom 1-the manufacture of items in acrylic. 2-work is the accuracy and efficiency of the control wire models

Fab academy 2012

CLASS 15: Machine Design Wed (May 2)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Project loom 1. Mobile elements are tested 2. proceed to install the micro servo 3. I asked for help to our colleagues, for the programming, the support that but I was Rimarachin

Fab academy 2012

CLASS 15: Machine Design Wed (May 2)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Loom assembled 1.In order to control the micro servo requires programming in c 2. will be used to work past weeks servos sealizo

Fab academy 2012

CLASS 15: Machine Design Wed (May 2)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Conclusions. 1. The construction of the card with the microcontroller and the light sensor is simple, however because we weld the parts. All information take it from the tutorials 2. The second part is complicated by the programming of the microcontroller, which was displayed not bar recognition of the sensor in your computer monitor. 3. By now the task is in progress.

CLASS 15: Machine Design Wed (May 2)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Conclusions. 1. was presented in the armed 2. you need 4 servos for the loom 3. By now the task is in progress.