+12V Constant =YELLOW

+12v Acc. Switched = VIOLET

-12V Chassis Ground = N/A

+12V Illumination =N.A

+12V Dimmer =RED/BLUE

Amp Remote =GREEN/WHITE

LF+ = WHITE

LF- = BLACK

RF+ =YELLOW

RF- = BROWN

LR+ = BROWN

LR- = BLACK/BROWN

RR+= BLUE

Dash Type :

Kit:Harness:Antenna Adapter: N/A

Interface Adapter(s):

About the Vehicle

Make: NISSAN

Model: MAXIMA

Year: 2004

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

1'' tweeter

Speaker Adapter : N/A

Factory Assembly : Plastic housing with (3) PHS screws

Rear

MAXIMANISSAN

2004

DIN

NN1498

NN03

RR- =BLACK/WHITE

Factory Assembly : Plastic housing with (3) PHS screws

NOTES

Front Pillar: Lower Door : 6.1/2" Midrange

Speaker Sizes

Bose system comes equiped with a 320 watt 8'' speaker system.

Dimensions:

Dimensions:

NOTES

Rear Deck : 6.1/2" speakers

OPTIONS

MP3 PLAYER ONSTARXM OR SIRIUS RADIODVD BASED ONSTARBOSE AUDIO SYSTEM

AMPLIFIER LOCATIONS: Located in the rear deck, in the trunk.

Aftermarket Kit: SINGLE DIN

NISSAN2004 MAXIMA

Images

Radio

Front Speaker

Rear

1. Using a panel removal tool pop out the trim panel under the door handle.2. Remove (2) 10mm bolts from behind this panel.3. Using a pick tool pop out the screw cover behind the door openerand remove the screw.4. Using a panel removal tool pop out the power window switch. Disconnect and remove.5. Using a panel removal tool pop out the door panel and pull upward. Disconnect and remove

1. Using a panel removal tool pop out the trim panel under the door handle.2. Remove (2) 10mm bolts from behind this panel.3. Using a pick tool pop out the screw cover behind the door openerand remove the screw.4. Using a panel removal tool pop out the power window switch. Disconnect and remove.5. Using a panel removal tool pop out the door panel and pull upward. Disconnect and remove.

Radio Removal

Front Speaker

Rear speaker

1. Unscrew the shifter knob base & push down. Carefully remove cotter pin securing top portion of shifter knob then lift knob up & away. Lift up shifter knob base & away.2. Using a panel removal tool, pop out the shifter panel, disconnect & remove. Extract (2) Phillips head screws from behind.3. Using a panel removal tool, pop out the radio bezel from bottom to top, lift away, disconnect & remove. Extract (4) Phillips head screws from behind, securing radio.4. Using a panel removal tool, carefully unsnap the navigation/data screen panel, lift away, disconnect & remove. Extract (2) Phillips head screws from behind, securing radio.5. Lift away radio assembly, disconnect & remove.

Front Pillar

1. Using front speakerremoval instructions con-tinue by using a PRT and pop out the plastic housing, disconect and remove.