+12v Constant = +12v Acc. Switch = -12v Chassis Ground= +12v Illumination = +12v Dimmer =Antenna/Amp Remote = LF+ =
LF- = RF+ = RF- = LR+ = LR- = RR+ = RR- =
Dash Type: Double DinAftermarket Type: Single/Double DinKit: GM1521BHarness: GM21SRAntenna Adapter: CRAB/CRARB
About the Vehicle
Make: CadillacModel: EscaladeYear” 2007-09
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
NOTES
Dimensions:
Dimensions: W= L= D=
NOTES
Standard/Optional
W= L= D=
Type: Location:
Speaker Sizes
CD PlayerMP3 CompatibleIn-Dash CD/DVD Changer10 Speaker SystemNavigation SystemRear View CameraRear Seat EntertainmentXM Satellite RadioOn Star / Hands Free Phone
Cadillac Escalade
"A" Pillar: 1" TweeterLower Door: 6 1/2” MidrangeSpeaker Adapter: SAGMHR634Speaker Harness: TBA
Rear Pillar: 1.5'' TweeterRear Door: 5” Midrange
2007-09
Images
Front Speaker
Radio removal
Front Speaker(s)
Rear Speaker(s)
Radio1. Using a PRT unsnap the cup holder/ashtray unplug and remove.2. Using a PRT unsnap trim above glove box.3. Using A PRT unsnap trim around stereo.4. Extract (6) 9/32 hex screws securing the factory radio.5. Lift away disconnect and remove.
"A" Pillar
1. Remove (1) 10mm hex bolt located in the door release cup.2. Located in the middle of the door panel behind the door handle there is a little panel hiding (1) 10mm hex bolts. Using a pick too remove the panel and extract the one hex bolt.3. Unlock the door to make sure the door lock pin is resting in its highest position. Release tab located at the bottom and lift up on the door pin to remove.4. Using a PRT unsnap the parameter of the door panel. Lift away disconnect and remove.5. Extract (1) 9/32 securing the factory speaker, lift away disconnect and remove.
1. Extract two 10mm bolts securing the A pillar handle.2. Using a PRT unsnap the top of the A pillar. Lift away, disconnect and remove.3. Tweeter is secured to A pillar by plastic snaps.
1. Remove (1) 10mm hex bolt located in the door release cup.2. Located in the middle of the door panel behind the door handle there is a little panel hiding (2) 10mm hex bolts. Using a pick too remove the panel and extract the two hex bolts.3. Unlock the door to make sure the door lock pin is resting in its highest position. Release tab located at the bottom and lift up on the door pin to remove.4. Using a PRT unsnap the parameter of the door panel. Lift away disconnect and remove.5. Extract (1) 9/32 securing the factory speaker, lift away disconnect and remove.
Rear Deck
Cadillac Escalade
Rear SpeakerRear Speaker
Tweeter
Lower Door
1. Using a PRT remove the rear panel running across the headliner from one pillar to the other.2. Using a pick tool remove the little oval panel covering the (1) Phillips screw.3. Extract (1) Phillips screw from the rear panel. Using a PRT unsnap pillar, lift away disconnect and remove. 4. Remove (1) Philips securing the factory tweeter to the pillar panel.
Rear Pillar
2007-09