Installation Instructions
Parts List
2 O2 eliminators1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Velcro
®
Strip1 Alcohol Swab
You can also download the PowerCommander software and latest maps
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
1 EFI Tuner
from the Dynojet web site at:
Fuel Moto 2215 Kelbe Drive Little Chute, WI 54140 (877) 729-4754 www.fuelmotousa.com
2007-2010 Harley Davidson Dyna
FM814 2007-2010 Harley Davidson Dyna - FM EFI Tuner - 1
1 Remove the seat
2 Remove the left hand side cover(Fig. A).
3 Unplug the stock wiring harness con-nector from the ECM (Fig. B).
4 Move the data plug (Fig. B) out of theway to access bolt.
5 Remove the 3 bolts that hold the elec-trical box in place (Fig. B).
6 Slide the plastic box out from theframe.
7 Route the stock connector through tothe back side of the electrical box(Fig. C).
Fig.
AFi
g. B
Fig.
C
Remove side cover
Stock connector
Stock connector
Data plug
Remove bolt
Remove bolts
FM814 www.fuelmotousa.com 2007-2010 Harley Davidson Dyna - FM EFI Tuner - 2
8 Lay the PCIII behind the electricalbox temporarily.
9 Route the GREY connector from thePCIII through the back of the electri-cal box and plug it into the ECM(Fig. D).
10 Connect the stock wiring harness tothe BLACK connector of the PCIII.
11 Zip tie these connectors to the frontside of the electrical box (Fig E).Make sure they are situated awayfrom the rear exhaust pipe.
Fig.
DFi
g. E PCIII connector
Stock connector
PCIII connector
12 Mount the PCIII to the underside ofthe stock ECM (Fig. F) using the sup-plied velcro. Make sure to clean bothsurfaces with the alcohol swab beforeattaching.
Situate the PCIII so the USB andexpansion ports point to the rear ofthe bike. This will allow you easieraccess to adjust the maps if necessary.
Fig.
F
USB port of PCIII
Stock ECM
PCIII
FM814 www.fuelmotousa.com 2007-2010 Harley Davidson Dyna - FM EFI Tuner - 3
13 Unplug the rear O2 sensor from thestock wiring harness (Fig. G). Thisconnector is located in the frameopening below the seat.
14 Plug one of the Dynojet O2 elimina-tors into the stock wiring harness(Fig. H).
15 Unplug the front O2 sensor from thestock wiring harness. This connectoris located near the front head pipe.
16 Plug the Dynojet O2 sensor eliminatorinto the stock wiring harness (Fig. J).
The stock O2 sensors are no longerneeded. If you leave them installedinto the exhaust pipes make sure thewires will not come into contact withthe exhaust.
17 Reinstall the electrical box using thestock bolts.
Fig.
GFi
g. H
Fig.
J
Unplug
Dynojet O2 eliminator
Dynojet O2 eliminator
FM814 www.fuelmotousa.com 2007-2010 Harley Davidson Dyna - FM EFI Tuner - 4