2008 Kawasaki Versys - PCIII USB - 1i228-411 www.powercommander.com
2008 Kawasaki VersysInstallation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
Parts List1 Power Commander1 USB Cable1 CD-ROM1 Installation Guide1 Power Adapter2 Power Commander Decals2 Dynojet Decals2 Velcro® Strip1 Wire tap1 Alcohol Swab
You can also download the PowerCommander software and latest mapsfrom our web site at:
www.powercommander.com
The ignition MUST be turnedOFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB PortExpansion Port
1 Remove the seat.
2 Remove the fuel tank.
3 Secure the PCIII in the tail sectionusing the stock band.
4 Route the PCIII harness towards thefront of the bike along the left handside of the frame (Fig. A).
5 Route the PCIII harness along the lefthand side frame tube (Fig. B).
6 Remove the bolts in the air box lid(Fig. C).
Fig.
AFi
g. B
Fig.
C
2008 Kawasaki Versys - PCIII USB - 2i228-411 www.powercommander.com
Remove these bolts
7 Remove the 4 bolts that hold the airbox to the throttle bodies (Fig. D).
8 Disconnect the air box temp sensorand hoses leading to the air box.
9 Remove the air box from the bike.
10 Unplug the stock wiring harness fromthe injectors (Fig. E).
11 Plug the PCIII connectors in-line ofthe stock wiring harness and fuelinjector (Fig. F) for both cylinders
Connect the ORANGE colored wiresof the PCIII to the left hand cylinder.
Fig.
DFi
g. E
Fig
F
2008 Kawasaki Versys - PCIII USB - 3i228-411 www.powercommander.com
Unplug the stock connectors
Remove these bolts
12 Locate the Throttle Position Sensorconnector on the left hand side of thethrottle bodies.
13 Unplug the TPS connector from thethrottle bodies to gain access to thewiring harness.
14 Crimp the supplied wire tap to theYELLOW wire with the WHITEstripe of the TPS harness (Fig. H).
15 Connect the GREY wire from thePCIII to the wire tap (Fig. H)
Note: It is recommended to use dielectricgrease on these connections.
16 Connect the TPS harness back ontothe throttle bodies.
Fig.
GFi
g. H
2008 Kawasaki Versys - PCIII USB - 4i228-411 www.powercommander.com
TPS connector
Wire tap
Grey wire from PCIII
17 Connect the ground wire from thePCIII to the negative side of the bat-tery (Fig. J).
18 Reinstall the air box.
19 Reinstall the fuel tank and seat.
Fig.
J
Ground wire