Date post: | 16-Dec-2015 |
Category: |
Documents |
Upload: | edidjo-darwin |
View: | 13 times |
Download: | 0 times |
ATU Audi Technical UpdatesElectronic Topics
2 Audi ATU 03/2011
Contents: Technical actionsElectronics
No. Event Topic Type/model
1 11/10 Fault finding: parking system All models
2 11/10 Fault finding: reversing camera All models
3 11/10 Fault finding: keyless entry A7, A8
3 Audi ATU 03/2011
Fault finding: parking system All models
Agenda
How the system works Environmental conditions Assessing the vehicle Performing tests without dismantling the system/without using the vehicle
diagnostic tester Performing tests without dismantling the system/using the vehicle diagnostic
tester Performing tests by dismantling the system/using the vehicle diagnostic tester Painting the parking system sensors Reversing camera
4 Audi ATU 03/2011
Fault finding: parking system All models
How the system works
One after the other, numerous sensors transmit ultrasonic waves; the sensors that are not
transmitting the waves 'listen'.
These sensors send the results to the parking system control unit.
The control unit functions when reverse gear has been engaged (if eight sensors are installed it is also possible to activate the unit via a button).
The unit initialises the entire system and commands the buzzer to make a brief sound. This
notifies the driver that the system is in working order.
If the event of faults, a long sound is emitted or the LED in the switch in the centre console flashes.
5 Audi ATU 03/2011
Fault finding: parking system All models
Issues a warning when no obstacles are present
Environmental conditions
The following conditions may impact or affect how the parking system works: A lot of foliage and kerbs Tarmac with large pores (gravel paths, cobblestones, potholes, metal grates), bends in the road, slopes,
approaches/ramps Storms and environmental influences, such as:
Water on the parking system sensors (broadens the side lobe) Ice/snow on the parking sensor or in the transition to the bumper Vehicle exhaust gases, steam (heat rolls, caused by revving up for example, change the physical
properties of the air, in order to transmit the parking system ultrasound) Interference noise (such as that from air brakes on lorries), rodent repeller, active parking systems
fitted in other vehicles Technology in local surroundings, such as fluorescent tubes, induction loops in traffic lights or car park
barrier controls
Please always ask which sensor is issuing the false warning and in which area.
6 Audi ATU 03/2011
Fault finding: parking system All models
Issues a warning when no obstacles are present
Assessing the vehicle
Check the number plate carrier assembly: The number plate must be exactly the
same size as the carrier The number plate and number plate carrier
must be flush The number plate must be secured at the
corners (check for corners curving upwards)
If possible, do not use advertising number plate carriers
7 Audi ATU 03/2011
Issues a warning when no obstacles are present
Assessing the vehicle
Add-on parts/conversions/retrofits that are outside the scope of Audi Genuine Accessories Towing bracket Lowering the ride height Spoilers Bumpers Noise amplifiers Rodent repeller
Preliminary damage covered by overpainting (note repair history)
Fault finding: parking system All models
8 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests without dismantling the system/without using the vehicle diagnostic tester Check the parking system sensors externally for:
Mechanical damage (chips, scratches) Dirt, ice, foreign bodies, film covering Damage to the bumper, air intake grille or underbody that indicates a parking dent Peeling paint
Chips and scratches are not covered by the warranty. Dirty sensors must be cleaned.
9 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests without dismantling the system/without using the vehicle diagnostic tester Exert pressure to ensure that the parking system sensors are fitted securely and correctly
Check that the decoupling ring is in the correct position
10 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests without dismantling the system/without using the vehicle diagnostic tester Check that the parking sensors are centred
Check that the sensors are flush with the bumper
11 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests without dismantling the system/without using the vehicle diagnostic tester
Check that the decoupling ring surrounds the sensor evenly
12 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests without dismantling the system/using the vehicle diagnostic testerQuery the entire data memory and proceed in accordance with Guided Fault Finding/Guided
Functions
It is also advisable to exchange the sensor in order to identify it as the definitive cause of the complaint.
13 Audi ATU 03/2011
Fault finding: parking system All models
Issues a warning when no obstacles are present
Performing tests without dismantling the system/using the vehicle diagnostic tester Note settling time in the measured value blocks (should be 0.81.5 seconds) Note interval evaluation in the measured value blocks (which sensor issues warning when required;
check/confirm the interval displayed) If deviations are determined, decouple the parking system sensor by covering it with foam;
this absorbs the ultrasound
If the obstacle warning is no longer issued once the sensor has been decoupled, please check the surrounding area/vehicle for any reflective objects and remove them. It is not necessary to replace the sensor in this instance.
The affected sensor must be replaced, however, if an obstacle warning is still issued even though the parking system sensor has been covered with foam and there is no visible damage or dirt.
14 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests without dismantling the system/using the vehicle diagnostic tester Check the coding in the parking system control unit using the Workshop Manual/SVM comparison
(e.g. for pre-repair work, retrofitting a towing bracket etc.) Check the part number read out using the tester against the parts catalogue
15 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests by dismantling the system/using the vehicle diagnostic tester Check the connections at the bumper, bumper coupling point, parking system control unit and
parking system buzzer for: Pins that are bent open Pins that have been pushed back Proper connector positioning Proper pin seal positioning Water penetration/traces of water corrosion
16 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests by dismantling the system/using the vehicle diagnostic tester Check the cables in the bumper for:
Damage/trapping
Example:
Q5: cable damaged when the number plate carrier secured
17 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests by dismantling the system/using the vehicle diagnostic tester Check the cables in the bumper for:
Sufficient length
Connections at the parking system sensors and coupling point
18 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Performing tests by dismantling the system/using the vehicle diagnostic tester Check the sensor bracket in the bumper for:
Damage/warping Secure fit Correct alignment Dirt
Check the sensors for: Warping/damage Secure fit Correct alignment Dirt Correct part number as per parts catalogue
19 Audi ATU 03/2011
Fault finding: parking system All models
Painting the parking system sensors
When painting replacement part sensors, the 'special painting instructions' for parking system sensors (from the paintwork guideline) must be followed
ElsaWin Internet Paintwork guideline Enter "Parking system" in free text search
Paint is not permitted in this area
The painting area is a minimum of 23 mm and a maximum of 8 mm from the front edge to the rear of
the membrane
20 Audi ATU 03/2011
Fault finding: parking system All models
Does not work/stops working sporadically/issues a warning when no obstacles are present
Technical product information 2024323/1*
* Always check for the latest TSB
21 Audi ATU 03/2011
Fault finding: Reversing Camera All modelsReversing camera
Please clarify the exact nature of the customer complaint "Reversing camera not working" could cover a number of complaints:
Image does not switch overIs reverse gear engagement identified?
Various messages have a higher priority:- Incoming call- Important traffic message- Catastrophe warning system
If the reversing camera image has been purposely deactivated, it will need to be
reactivated -> See video in "Video" folder
Screen is blackIs it just the reserving camera image that is black?Can the parking system bar chart be seen?
22 Audi ATU 03/2011
Fault finding: Reversing Camera All modelsReversing camera
Please clarify the exact nature of the customer complaint "Reversing camera not working" could cover a number of complaints:
Image is fuzzy
- Recalibrate camera
- On large screens, the image is slightly fuzzy at the corners, as
the image needs to be interpolated the most here nature of the technology
23 Audi ATU 03/2011
Fault finding: Reversing Camera All models
Reversing camera
Please clarify the exact nature of the customer complaint "Reversing camera not working" could cover a number of complaints:
Image flickers
Check cabling/connector to MMI/reversing camera control unit and reversing camera
Menu option in MMI is missing
Check the adaption channels in the MMI; check which part numbers have been installed
In addition, please clarify the situation with the following general conditions Is the LED in the parking system button lit? Do the parking system settings in the MMI match the customer's requirements? Is the parking system audible? Can the function be reactivated by switching the system on and off again using the button?
24 Audi ATU 03/2011
Fault finding: Reversing Camera All models
Reversing camera
It is not possible to recalibrate the reversing camera Reflections on the calibrating plate caused by poor light irradiation Calibrating plate is not aligned correctly
Not centred to the Audi rings, but to the vehicle dimensions Camera installation position in the vehicle is different
Even minimal changes to the installation position result in angle deviations that may not be compensated during the calibration process
Note repair history of rear lid area
0MMI screen frame
Bumper image
Using a tiled floor (joints) will make it easier to ensure the
ideal alignment of the vehicle, calibrating plate and camera
25 Audi ATU 03/2011
Actual: Advanced Key no function at the doors A7 / A8
Service note: Advanced Key no function at the doors A7, A8
Complaint Advanced Key no function at the doors Engine start via Advanced Key OK
Technical background Standard equipment: keyless engine start (Keyless Go) Optional equipment: keyless opening and closing (Keyless Entry) Not visible at the vehicle
Start-Stop-Button always equiped Door handles always equal from outside view
Measure Check PR-number in the vehicle data, if Keyless Entry is installed
26 Audi ATU 03/2011
Thank you.
ATU Audi Technical UpdatesContents: Technical actionsElectronicsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: parking system All modelsFault finding: Reversing Camera All modelsFault finding: Reversing Camera All modelsFault finding: Reversing Camera All modelsFault finding: Reversing Camera All modelsActual: Advanced Key no function at the doorsA7 / A8Slide Number 26