20120515 4 Daylight v20 - enoluz.com · • Manual overriding control as required ... Coverage ø8m...

© www.enoluz.com > [email protected] – Eco friendly-efficient-easy > 15-May-12 Page 1

Daylight CONTROL

4.


Daylight Control 1-10vLigth sensor to use directly to the 1-10v ballastUT30072

Range: 20…1000 lux

Indoor Use IP20

To use with:

1..10V controlled ballastsDimLight-10/LRDimLight-10/CR

Works with reflected light coming from walls, working plane, etc..normally we mount it in the ceiling in center of the room. Be aware of a very simple function and product. You can connect up to 50 pcs 1-10V units (ballast, dimmers, etc).


Daylight Control 1-10vDirect connection to Ballast, controllers

UT10296350 VA controlled by 1-10v

UT10302700 VA controlled by 1-10v

1-10v ballast

LED 230V TubeDLU-10 ref. UT30072

Range: 20…1000 lux

Indoor Use IP20

Downlight + AC dimmable PWM LED driver


The product converts a 0-10V voltage into a 1-10V signal. This enables dimmable electronic ballasts can be controlled with analog input. Thanks to the sink current of 150 mA can also be large amounts of electronic ballasts controlled simultaneously.

Inputs and outputs control0-10 VDC

Suitable lampsFL with 1-10V ballasts

+

50x50x30 mm

Range: 1…16.000 lux

Output voltage: 1…10v

UT80091

S221-90100Output voltage: 0...10v4 lux ranges:- 3...300 lux- 30...3.000 lux- 300...30.000 lux- 600...60.000 lux

V43-197

Light SensorsLS10 UT80091 and V43-197 1-10v Sensors+ SUK_01_10v converter

InputSupply voltage24 v dc ± 10%

InputSupply voltage 12 v dc


Daylight Control 1-10vUT80213

• Simple and straightforward in operation and programming.• Separate output available for e.g. blackboard lighting• PIR sensors are directly connected• Manual overriding control as required• Wireless remote control available

LS-10


DLC-ANALOG-31Daylight Control 1-10v


Wireless ControlIt’s possible to add a wireless Receiver to the inputs 6,7,8 and 27, 29

Control 1-10v 3 zones

LSD PIR

Circuito on-off

Standby ballast

ReceiverWireless Receiver

(optional)

ANALOG Control 3 zones2º unit connection in parallel

Conventional switches

1 2 3 4 on-off1..4


5. Gateways-Converters ANALOG 1-10v-DALIAvailable with 1 & 4 1-10v inputs


DALI-based multi-sensor with 4 separate zones which 3 zones, daylight-driven, and the fourth zone designed for example: blackboard.Illuminates with operating pressure, or automatically via PIR. Daylight controls can be overridden as needed. Lights automatically turn off via PIR, or manually with the operation pressure.

On-off

CLS-DALI-31 – All in ONE SENSOR !Dimming 3 zones + 1 output on-offRegulación 3 zonas + 1 salida de rele on-off


CLS-DALI-31 Daylight 3 zones + 1 on-off

230Vac + DALI

230Vac + DALI

230Vac + DALI

CLS-DALI-31

Zone 1

Zone 2

Zone 3

Zone 4

Zone 1-3 ON/OFF Zone 1-3 DIM

Zone 4 ON/OFFLow voltage installation (SELV) 3x0.6


CLS-DALI-31 Regulación 3 zonas + 1 salida de rele on-off


MS8-360-4D 4 zones daylight control


Wireless EnOcean Sensor

Wireless DALI

5.


Wireless Sensors PIR EnOcean

Solar sensor working illuminance min. 80 lux

360º coverage 12 meters

Radio transmission: up to 50 m

Use: Manual ON – automatic OFF

Elegant Design 23 mm diameter and 6 mm high y 6 mm de altura

360º coverage

Wireless connection with PIFE transmitter

PD-360 PIFE

PDE-360SC

220v Mains

EnOcean radio transmitter

2 PIR PD-360 connection

2 x

+


Lighting control in corridors

+2 x


MS8E-360-2LV | PRESENCE CONTROL | WIRELESS OVERRIDE

Coverage ø8m (height = 2,4m)

PIR sensor – 2x10Amp

Adjustable PIR timer (15-180min)

Output for lighting

Configuration with remote control

Wireless override

Output for ventilation

Extended coverage through slave PIR

Adjustable lux-level (50-500Lux)


MS8E-360-2LV + MS8-360-SL slave

MS8E-360-2LV230Vac Ventiilation ON/OFF

MS8-360-SL

Override ventilationOverride lighting

Master/slave connection 1-wire


Wireless DALI

DALI-EnOcean Gateways –DALI groups previously created-

OPCION 1:

CLSE-DALI-31 Dimming 3 zones with wireless manual control

OPCION 2:

DALI 4 zones with 2 lighting levels for Hospitals

OPCION 3:

EnOcean DALI BROADCAST (no commissioning)


DALI-EnOcean Wireless Gateways

DALI-EnOcean Gateway

20 mA consumption

64 ballast

16 groups

16 scenes

DALI-EnOcean Gatewaywith DALI power supplyincluded

1 channel receiver

On-off and Pulse output

Flush mounted

Easy link to transmitter untill 50 switches

Scenes creation

Relés para conexión a todo tipo de fuentes de iluminación y cargas

Salida libre de POTENCIAL


Switching&Dimming DALI groups wirelessly with EnOcean

230V~Mains Osram Osram

HTiHTi DALI (150W)DALI (150W)

PowerDRIVE180W series

Constant Current 200mA-1050mA

4 independent channels

EnOcean-DALI Gateway64 ballast16 groups

12-32Vdc

Rxe DIN DALI with PS DALI included


Option 1: CLSE-DALI-31 – All in ONE SENSOR!EnOcean Wireless version –Dimming 3 zones-

On-off

DALI Dimming 3 zones. DALI switch on-off possible.

Saving cost installations. Automatic ballast searching and polling into 3 zones.

Automatic Daylight control and manual override with EnOcean wireless.

Easy commissioning by remote handheld for illuminance setpoint and zones distribution ballast.


CLSE-DALI-31 scheme + MS-DALI-SL

230Vac + DALI

230Vac + DALI

230Vac + DALI

CLSE-DALI-31

Zone 1

Zone 2

Zone 3

Zone 4

MS-DALI-SL

Zone 4 ON/OFF

Zone 1-3 DIMZone 1-3 ON/OFF


MS8E-360-4Dwith Wireless Control


MS8E-360-4Dwith Wireless Control


Option 3: Daylight Control DALI broadcast-EnOcean no commissioning


More infowww.enoluz.com

www.enoluz.comTel. + 34 91 209 [email protected]

Date post:	27-Jul-2018
Category:	Documents
Upload:	doandat
View:	218 times
Download:	0 times

20120515 4 Daylight v20 - enoluz.com · • Manual overriding control as required ... Coverage ø8m...

Documents