Date post: | 21-Dec-2015 |
Category: |
Documents |
View: | 250 times |
Download: | 4 times |
112/04/18 2
Network Setting TransCAD supports four types of network
settings: Link type codes – When you want to use link type
turn penalties or when you want the results of analytic models to be summarized by link type
Turn penalties – When you want to model the cost or delay that is associated with all turns, is based on link type, or is specifically for moving from one link to another
Centroid connectors – When your network contains centroid nodes and you want to avoid movements through those nodes.
Transfer penalties – When you want to model the cost or delay associated with transferring between different line types, such as from a rail line to a truck line.
112/04/18 5
Turn Penalties
Most TransCAD procedures let you apply restrictions, penalties, or delays when turns are made between links in a network. Some situations when this is useful are: Turns that are physically or legally prohibited Signalized or congested intersections which result
in delays for traffic in one or more directions Delays that occur when there is a transition from
one type of link to another (e.g., from on-ramps to a highway or at toll plazas for tunnels and bridges)
112/04/18 6
To Include Turn Information in a network
To specify if there are
special type of link will
include the turn penalty
112/04/18 8
Using the Turn Penalty Toolbox TransCAD provides tools to help you
create and edit specific turn penalty tables. With these tools, you can: Create a specific turn penalty table Display specific turn penalties on a map Interactively add, edit, and delete specific
turn penalties
112/04/18 10
Left turn with penalties
Remove Panelties
Choose Penalties
Add a Penalty
Hide and Show
Type Penalty Value
Apply to Network
112/04/18 11
Centroids
Centroids are special nodes in a network that represent the center of a transportation analysis zone. In many transportation forecasting applications, trip either start or end at centroids. You identify centroids by creating a selection set. The links that connect centroids to the other links in a network are known as centroid connectors.
112/04/18 14
Transfer Penalties
In some networks, there is a cost associated with changing from traveling on one line type to another. For example: When freight is transferred from one mode
to another, a cost or delay is incurred Transferring from a ramp to a highway can
cause a delay and may involve a cost
112/04/18 15
To Include Transfer Penalty Information in a Network
Column Penalty needed
After this, Then Create a Network
File