MACHINE TO MEASURE THE BULK DENSITY OF CERAMIC TILES BY MEANS

OF X-RAY ABSORPTION

Ceramic

WorldPremiere!

Versión_20170518

Densexplorer Measurement:

Advisable Measurement of clean and air-conditioned room for the installation of

Densexplorer 750. (Densexplorer 1100 min. 4x4)

Software abilities

- Software specially design for easy control of the device and

adapted to the ceramic sector.

- Allows to create Bulk density maps of all the tile/piece both raw

or cooked.

- Allows to obtain mass distribution, load and thickness

information.

- Detection of point defects in relation with bulk density

distribution.

- Study of chosen tile/piece sections by the user.

- Quick comparison between pieces of the same press.

- Production data export through USB or Ethernet.

Load distribution map. 3 exists Density profile of selected section

Technology

- Machine made of one X-ray generator and two laser range

finders.

- Chance of direct communication with our technical service to

solve any problem through telematics.

Advantages

- Non-destructive, it allows to examine both raw and cooked tiles.

- Full analysis of a 60 x 60 tile in only 5 minutes.

- Completely safe system for the employee (certified by the Nuclear

Safety Council) and the environment (no waste is produced).

Model DENSEXPLORER 750 DENSEXPLORER 1100Precision/accuracy SafetyProduct size Maximum width:750 mm Maximum width: 1100 mmPower of generatorTension / required Power Weigth 350 kg 450 kgWorking/storage temperature Construction materials

100 W3~L1/L2/L3/NE/PE 400 Vac. ±10% three-phase, 50/60 Hz / 6,9 kW

+20 a +30 ºC / -5 a +50 ºCStainless steel AISI-304, duralumin and polymeric materials adapted to the industry legislation

~3 kg/m3Machine certified by the Nuclear Safety Council and marked with CE

Table with PC