Date post: | 25-Jan-2017 |
Category: |
Engineering |
Upload: | mohammed-limdiwala |
View: | 457 times |
Download: | 2 times |
Babaria Institute of TechnologyEngineering
Thermodynamics
Prepared by :- Burhani Burhan A.(9011) Bhimani Vipul (9010)
Mchanical-1-A
Second law of thermodynamics
Concept • Introduction of 1st law of thermodynamics.• Limitation of 1st law of thermodynamics.• Introduction to 2nd law of thermodynamics.• Kelvin-plank statement• Clausius statement • Equivalence of Kelvin-plank and Clausius statement• PPM 2• Carnot cycle and Carnot heat engine • conclusion
Why 2nd law of thermodynamics
• The 1st law of thermodynamics states that a certain energy flow takes place when a system under goes a process or change of state.
• δW=δQ • But , it does not give any information on whether
that process or change of state is possible or not.
According to 1st law of thermodynamics
• Work is completely converted in to heat or heat is completely converted into work.
(δW = δQ and δQ=δW)• Potential energy can be transformed into kinetic
energy or kinetic energy can be transformed into Potential energy.
(PE→KE and KE→PE)• Heat flows from hot to cold or from cold to hot.(Th → Tl and Tl → Th)• Gas expands from high pressure to low pressure or
from low pressure to high pressure .
Limitation of 1st law of thermodynamics
• Heat is not completely converted into work.(Q ˃ W)• kinetic energy can not be transformed into
Potential energy.(KE ≠> PE)• Heat flow from cold to hot is not possible.(Tl ≠> Th)• Gas expands from low pressure to high pressure is
not possible.
Limitation of 1st law of thermodynamics
• 1st law does not help to predict whether the certain process is possible or not.
• A process can be proceed in particular direction only , but 1st law does not gives information about direction.
• 1st law not provides sufficient condition for certain process to take place.
2nd law of thermodynamics
Heat can not flow itself from cold body to hot body.
• The 2nd law of thermodynamics is also used to determine the theoretical limits for the performance of mostly used in engineering systems like heat engines and refrigerators.
Thermal energy reservoirs
• It is system that supply or absorb finite amount of heat without any change in its temperature.
Heat engine • Heat engine is a system that converts heat into work or
mechanical energy .• It absorb heat at higher temp body and rejects at
lower tem body.• It is work producing device.Ex – power plant (it operates on a complete cycle)
Heat engines Process -1. they receive heat from a high-temperature source.2. they convert part of this heat to work.3. they reject the remaining waste heat
to a low temperature sink atmosphere.4. they operate on a cycle.
Heat engines
• For a heat engine the efficiency is the ratio of net work done and the heat supplied.
thnet out
in
in out
in
out
in
WQQ QQQQ
,
1
where,W W W
Q Qnet out out in
in net
,
Heat pump and Refrigerator
• A device that transfers heat from a low temperature medium to a high temperature is the heat pump.
• Refrigerator operates exactly like heat pump , but difference is that heat pump maintain heated space at high temperature reservoir and refrigerator maintain heated space at low temperature reservoir.
• They are work consuming device
Heat pump and Refrigerator
Heat pump and
Refrigerator
Kelvin plank statement It is impossible to construct a heat engine that
operates on cycle to receive heat from single reservoir and produce equivalent amount of work.
It implies that it is impossible to build a heat engine that has 100% thermal efficiency .
Clausius statement It is impossible to construct a device as heat
pump that operates in a cycle and produces no effect other then the transfer of heat from a lower temp body to higher temp body.
Heat can not itself flow from colder body to hater body.
It can be shown that the violation of one statement leads to a violation of the other statement, i.e. they are equivalent.
1. Violation of Kelvin-plank statement leading to violation of Clausius statement .
2. Violation of Clausius statement leading to violation of Kelvin-plank statement .
Equivalence of the Two Statements
Violation of Kelvin-plank statement leading to violation of Clausius statement .
Violation of Clausius statement leading to violation of Kelvin-plank
statement .
PMM2 - Perpetual Motion Machines of the Second Kind
• It is against the Kevin-Planck statement: it is impossible to build an 100% heat engine.
Violate the Second Law of Thermodynamics
-:Thank you:-
Any questions ?