Date post: | 22-Nov-2014 |
Category: |
Business |
Upload: | arongonzalesarnao |
View: | 940 times |
Download: | 0 times |
Fab academy 2012
CLASS 9:3D scanning and printing (Mar 21) STUDENT: WALTER HECTOR GONZALES ARNAO
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012
FIRST STEP. is chosen in order to experience quick scan that is 10 cm high CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012
STEP TWO. scanner takes pictures in revolution, as seen in the images selected for this purpose CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012
STEP 3. install the program to work the volume scan CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012 STEP 4. then the volume identifies areas that have holes to cover
them and that the 3D printing machine Acknowledge it without problem CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012 STEP 5. commands that allow for the filling operation can be
displayed in grid mode of amending the rhino also CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012 STEP 6. the rhino is easier to change scale
CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012 STEP 7. opens the file in the software up to prepare for printing
CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012 STEP 8. volume is entered in the software modified UP! 3D
printing CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012 STEP 9. once the 3D scan is taken supercie part of the contact
and then proceeded to withdraw the burr that is in contact with the scanned object CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012
STEP 10. appreciated that the bed volume is scanned, which allows easy disassembly, after completion of the operation CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012
STEP 11. shown in the detail photos of the impression that it is not as accurate CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES
Fab academy 2012
STEP 12.SE turned on the LET CLASS 9: 3D scanning and printing (Mar 21)
UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES Conclusions.
1. reproduction is not as accurate, because the level of detail of the original ceramic finishes imperfect 2. volume changes were made in the rhino scanstudio and then to close the holes, the latter is faster