+ All Categories
Home > Documents > A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin...

A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin...

Date post: 30-Dec-2015
Category:
Upload: paul-wiggins
View: 233 times
Download: 3 times
Share this document with a friend
Popular Tags:
12
A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility, CCLRC Rutherford Appleton Laboratory, Chilton, Didcot UK
Transcript
Page 1: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

A 5 fs high average power OPCPA laser system for

attosecond pulse production

Philip Bates, Yunxin Tang, Emma Springate and Ian RossCentral Laser Facility, CCLRC Rutherford Appleton Laboratory, Chilton, Didcot UK

Page 2: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

OPCPA can produce more energetic few-cycle laser pulses

• Current system: Ti:Sa amplified system + hollow fibre broadening

• Gain narrowing in Ti:Sa limits amplified pulse duration to 20-30fs. Typical systems have energies ~1mJ

• Hollow fibre required to broaden spectrum to 5fs level with limited throughput

• OPCPA allows us to maintain full spectrum throughout amplification

• Requires more complex stretcher compressor design• Energy limited only by available pump laser

Page 3: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Optical Parametric Amplification

• Process obeys energy conservation and phasematching– ћωseed + ћωidler = ћω pump

– nsωseed + niωidler = npω pump

• Very broad bandwidth esp. in non-collinear geometry• Pump beam aberrations and phase errors transferred to

idler– φidler = φseed - φpump

• No thermal deposition in gain medium, no thermal loading• High Gain with efficient extraction of pump energy

Pump

Non-linear crystal

Idlerћωp

ћωI

ћωs

Amplified Seed

Depleted Pump

Seed pulse

ksignal 1kidler 1

ksignal 2kidler 2

kpumpα = 1.2°

Page 4: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

OPCPA has broad gain spectrum

• Monochromatic pump pulse amplifies broadband chirped seed pulse

• 40ps Pump pulse duration 2x chirped seed

• Phase-matching angle chosen to give largest gain bandwidth

• Saturated Gain bandwidths > 400 nm

• Output energies– 23% extraction efficiency– Up to 20 mJ with 85 mJ

pump• Can amplify full 5fs

spectrum

Page 5: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Stretcher-compressor designed for 400nm BW

• Ti:Sapphire 12 fs oscillator

• CEP stabilised• Broadened to 400

nm in optical fibre• 3-component

stretcher: prisms+ gratings + Dazzler

• Recompressed in transmission grating compressor

C-E phase stabilisation

AOM

OscillatorFibre -broadening

Dazzler

Prism stretcher

OPA stages

compressor

Grating stretcher

Verdi

Page 6: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Grating stretcher includes system of 8 lenses

• Angular magnification -1 for all wavelengths across bandwidth

• Preserves collimation of input beam

• Minimal change in group delay across our 2mm beam

• High-order phase terms from glass can be compensated for in rest of stretcher system

~80 mm

Page 7: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Stretcher compressor calculations

• 8-prism system compensates for high-order phase terms due to glass in Dazzler and grating stretcher lens

• Compressor uses large out of plane angle to balance some high order phase

• Residual chirp designed to optimise Dazzler correction for high efficiency

Page 8: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Fibre Broadening

• Current oscillator bandwidth of 250 nm has transform limit of 11.2 fs

• Need spectrum covering 700-1100 nm to get 5 fs pulses and match gain in OPA

• Single-mode fibre– not enough broadening

• Photonic crystal fibre– Too much broadening

so some energy outside gain bandwidth

600 800 1000 1200-50

0

50

100

150

200

250

300

350

400 HiBi 750-3 7mm 177mW with Iris Oscillator (both corrected)

Inte

nsity

(arb

)

600 800 1000 1200-50

0

50

100

150

200

250

300 NL 2.4 140mW with iris Oscillator (both corrected)

Inte

nsi

ty (arb

)

Page 9: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Recompression of fibre-broadened pulses

• Recompressed output of fibre with Dazzler and prism system

• 3 types of fibre tried, all single mode:

1) PM silica

2) Anomalous dispersion PCF

3) Normal Dispersion PCF

• Recompressed to ~18 fs but all show signs of double pulses and variation across beam spatially

Broadened Spectra (Corrected) from SC-5.0-1040 7mm long

-50

0

50

100

150

200

250

300

600 700 800 900 1000 1100

Wavelength

Inte

ns

ity

(a

rb)

154mW corrected 194mW corr

Page 10: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Diode-pumped Nd:YLF pump laser

• Pump with 25% duty cycle• Synchronised to Ti:Sa oscillator

1mJ, 1 kHz 40ps1047 nm regen

Diodes

Diodes

SHG

5 x 1 kW diode bars

100 X 5 mm Nd:YLF rod

Page 11: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Current output of Nd:YLF pump laser

• Current setup: 3 pass amplification• Output pulse energy up to 80mJ• Damage to rod coating at 80mJ

3-pass amplification

0

20

40

60

80

100

40 60 80 100 120Diode Current (A)

Out

put

Ene

rgy

(mJ)

0

0.5

1

1.5

2

Flue

nce

(J/c

m2)

Output Energyfluence

Rod coating damaged

Amplified beam profile3rd pass on rod ~60mJ

Page 12: A 5 fs high average power OPCPA laser system for attosecond pulse production Philip Bates, Yunxin Tang, Emma Springate and Ian Ross Central Laser Facility,

Summary

• OPCPA allows amplification of full 5fs pulse bandwidth and hence higher power pulses

• Transmission grating stretcher and compressor system including prism stretcher and Dazzler

• Best compression within 1-2fs of transform limit of oscillator spectrum without dazzler

• Fibre broadening has limited success so far• Initial pump laser tests promising with 80mJ output• Two-stage OPCPA amplification is being designed• Gain bandwidth tests of OPA crystals to begin soon


Recommended