Activity: Emission spectroscopy and

smart sensors

What is a Smart Sensor? We will use the term “Smart Sensor” to refer

to systems that employs a sensor device mated to microelectronics. In this activity we will use a light emitter and a spectrometer for our sensor system and a computer will take the place of the microelectronics. The system used in this activity is not engineered to minimize size and power consumption but clearly those would be goals in any widely deployed commercial device.

Preparation for Activity

Items Needed: Ocean Optics Red Tide USB 650 Spectrometer, optical fiber lead for spectrometer, Computer with Ocean Optics Spectra Suite. Laser pointer light sources red, green; other light sources.

An understanding of various emission light sources

InstructorTo initiate the activity discuss the emission of light from a laser pointer-lead students into a discussion of some of the principles of solid state lasers. Be prepared to discuss some of the major ideas behind solid state lasers and simulated emission. Read sections on quantum effects and the laboratory on emission spectroscopy

Safety Consideration

WARNING: The output of the solid state lasers in laser pointers and other devices is potentially dangerous and one needs to insure that the light is not directed into the eyes of students, graduate assistants or faculty members

A Red Tide USB650 spectrometer system

A “Red Tide” CCD detector based spectrometer, A CCD is an acronym for a charge coupled device: Here a linear array of silicon sensors that responds to light. In the spectrometer light is broken down into component wavelengths by an interferometer and the output at each wavelength sensed by the CCD sensor. The spectrometer covers the wavelength range 350 nm to 1000 nm.

Optical fiberEnd on view of the optical fiber showing glass interior. Optical fibers for the Rid Tide 650 can be obtained for a variety of wavelength ranges.

A Red Tide USB650 spectrometer system with USB link and optical fiber attached

A “Red Tide” spectrometer connected to an optical fiber(red/blue) and a USB computer interface (clay ). The USB link is used to bring power the spectrometer and transmit data to the computer. Light is brought to the spectrometer using the optical fiber.

Experimental

Direct the output of the laser to the open end of the optical fiber. It is useful to have the fiber and light source well secured so that experiments testing smart sensor designs can be easily carried out.

Questions

What observations can you make concerning the nature of the red and green laser spectra?

What problems do you see in the design of this activity? What improvements would you make?

What other kinds of measurements can you see being carried out with this system both indoors and out.

Design

Based on your observations during this activity design smart sensor systems for two different tasks.

What would be necessary to build a smart sensor system ( somewhat like the system discussed in this activity) capable of detecting a specific airborne chemical.

Red Laser Pointer

0

500

1000

1500

2000

2500

3000

3500

4000

4500

350 550 750 950

nm

Rel

ativ

e In

ten

sity

Series1

Red Laser pointer

Green laser pointer

Green LED

0

50

100

150

200

250

300

350

400

350 550 750 950

nm

Rel

ativ

e In

ten

sity

Series1