Date post: | 17-Dec-2015 |
Category: |
Documents |
Upload: | magnus-obrien |
View: | 218 times |
Download: | 1 times |
ADTX Threshold Scan
RIKEN/RBRCItaru Nakagawa
1
Run13 ADTX Threshold Scan
• March 3, 2013• MUID1D • HV=Run12 Nominal Setting• MuTrig e-Log entry=#1127
2
Run13 ADTX Threshold Scan Run# Threshold [mV] BBCnVTX [MHz] MUID1D
[events]ST-1 Logic
385751 40 1.39 6.5M AND2385752 60 1.36 4.5M AND2385753 20 1.34 1.6M AND2385754 10 1.32 1.3M AND2385755 100 1.31 2.7M AND2385756 80 1.29 1.6M AND2385757 80 1.27 1.8M OR385758 100 1.26 1.7M OR385759 60 1.25 0.5M OR385760 60 1.24 1.5M OR385761 40 1.23 1.6M OR385762 20 1.22 0.3M OR385763 10 1.22 0.5M OR
3
Fake Hit Rates (South)
Logic=AND2 Logic=OR Logic=OR
Octant-3 doesn’t necessarily stands out -> AND2 effect?
4
Sanghwa’s Gap-by-Gap Threshold Scan
Feb.2013
South St-1 Oct-2 Gap-2 Noisy
5
Fake Hit Rates (North)
Logic=AND2 Logic=OR Logic=OR
North Station-3 Octant-1 stands out
Vertical Axis : (average hits/strip)/total#of_trigger / 106ns [Hz]6
Inter Station Comparison (South)
7
Inter Station Comparison (North)
8
Accidental Coincidence Fake SG1 Trigger
• SG1 ~ R_st1 x R_st2 x R_st3
9
Accidental SG1 Prediction
10
Accidental SG1 Prediction
North Octant-1 Stands out, but not Octant-4
11
SG1 Rate Octant Fraction (South)
Red Dot : EmulatorHorizontal Bar : Prediction from Fake Rates
Compares Actual SG1 Trigger Rates/oct from Emulatorand Prediction from Fake hit rates.
Run#385753 : Threshold=20mV
12
SG1 Rate Octant Fraction (North)
Red Dot : EmulatorHorizontal Bar : Prediction from Fake Rates
Run#385753 : Threshold=20mV
Disagree more than 3sigma.Both plots are from same data. Why? Deadtime?
13
Inter Station Comparison (South)
14
Inter Station Comparison (North)
15
Normalized
Load Map to Threshold Optimization• Before Run13 : Thresholds are set to be constant
charge efficiencies.• Run13 Concept– R_oct1=R_oct2=R_oct3=…= R_oct8 – Raise threshold of station which has steeper response to
threshold regardless of noisy source St.• Analyze Charge efficiency– Eff_AND2 -> [1 - (1-eff_g1xeff_g2)x (1-eff_g3)]
• eff_g? = 0.9 => Eff_AND2=0.98
– Eff_OR -> [ 1- (1-eff)^2] • eff=0.9 => eff_OR=0.99
16
Run12 Eff=95% Config
17
BACKUP
18
(Log)
19
(log)
20