AISG-AIMAntenna Identity Module

This Antenna Line Device (ALD) is retro�t mounted permanently onto the GSM/UMTS antenna back and connects to the AISG connector of the RET activator motor. The AIM is automatically detected by the Primary CCU or Node B.  The Primary can read the AIM �elds that identify the antenna data.

Read-only. During installation relevant antenna data can be burned in the AIM memory using the AIM Field Programmer (AFP),After programming these data �elds are READ-ONLY  and thus represent the exact antenna information with no risk of losing integ-rity of the Data.

With this module the primary can now identify what type of antenna’s are installed independent from the RET motor. Especially when the Ret motor is upgraded or swapped the Identity of the antenna stays unchanged.

AISG-AIM key features:

No phisycal site visit required to check the identity of an antenna.

Field upgradable to future AAS and CAD speci�cation.

Quick and easy installation on antenna.

AISG version 2.0 Compliant (virtual RET)

Made in the Netherlands | www.spaa05.com | info@spaa05.com | +31 416 565 005

SPAA05.comAntenna alignment solutions for professionals

®

AISG-AIM Technical speci�cations

Made in the Netherlands | www.spaa05.com | info@spaa05.com | +31 416 565 005

CommunicationAISG Protocol V 2.0

Connectors8-pin circulair connector conforming to IEC 60130-9 Ed. 3.0

MechanicsDimensions: length 2.7 cm width 2.3 cm height 0.7 cmWeight: 0.030 kgCable: length 60.0 cm

OptionsAvailable with straight or right angled connector

PowerType: DC 10 - 30V power consumption: 4 mA

EnvironmentalOperating temperature: -40°C to 125°C (-40°F to 257°F)Storage temperature: -40°C to 125°C (-40°F to 257°F)Humidy: 95% non-condensingProtection: IP68

Read only fields• Antenna Model• Antenna Serialnr • Antenna Frequency bands• Antenna Beamwith per band• Antenna Gain per band• Antenna Tiltrange

© Copyright 2010, SPAA05.com. All rights reserved. Speci�cations subject to change without notice.SPAA05, SPAA05.com, SPAA05-MTS and their respective logos are registered trademarks of SPAA05.com.Made in the Netherlands. Patent pending.

SPAA05.comAntenna alignment solutions for professionals

®

MEMBER OF