57
ANSYS-FLUENT Tutorial Dr. Mohammad O. Hamdan United Arab Emirates University Spring, 2010
| Date post: | 02-Nov-2014 |
| Category: |
Documents |
| Upload: | ramkumar121 |
| View: | 288 times |
| Download: | 15 times |
ANSYS-FLUENT Tutorial
Dr. Mohammad O. Hamdan
United Arab Emirates University
Spring, 2010
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
1) Drag and drop Mesh icon
2) Double click Geometry
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Select any line from the
sketch and then hit Apply
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Put thickness 0.01 m
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
ApplyApply
Dr. Mohammad O. Hamdan
Apply
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
In_flow
out_flow
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Drag and drop on mesh
icon
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
0.10.1
Dr. Mohammad O. Hamdan
Fluid then OK/OK/
Dr. Mohammad O. Hamdan
Yes… change
Dr. Mohammad O. Hamdan
Change V_in=1 m/s
Dr. Mohammad O. Hamdan
Yes… change, then P=0, OKYes… change, then P=0, OK
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Change to 100
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
X=0 and Y=1
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
Dr. Mohammad O. Hamdan
United Arab Emirates University
Good Luck in you CFD career
