1
SPECIFICATIONS TROUBLESHOOTING “EGO II” LEVER HANDLE FLOOR STANDING SINGLE LEVER BATH & SHOWER SET S06725 CHECK POINT Water leaks around the handle 1 Tighten Handle is loose 2 Tighten PROBLEM SOLUTION 7 Hex. Key Cover Body Swivel Ring OPERATING CONDITIONS Water supply pressure : 0.05 ~ 0.75 MPa. Ensure that water supply is clean ( No Sand, Dirt, Etc.). 1. 2. Always wipe chrome plated area with dry soft cloth, and sometimes wipe it with cloth soaked in mild soap. MAINTENANCE R5 INSTALLATION 1 3 Sleeve Anchor * Cut the cover after the mortar dry 5 2 Screw 6 4 * Plastic Cover 6 X Ø6 Holes Floor Water Pass Make sure floor is flat Hot Water Supply Cold Water Supply Mortar Minimum Mortar Level Maximum Mortar Level Base COLD Cover a b Bolt Hex. Key Cap Body * Remove the Base Cover and keep the Bolt HOT Bolt (From step 6) 2. BOLT Flow Regulator Inside (Don’t remove) 1. CONNECTING NUT 8 Packing Flexible Hose Shower Rain Spray Button Massage Spray Button Packing 751 +20 0 55 +0 -20 Ø95 75 +0 -20 945 +20 0 637 +20 0 230 45° 51 30 697.5 +20 0 Floor 30 TX494SEL ATTENTION Use of abrasive cleaning material such as; detergents containing hydrochloric acids, thinner, polishing powder, and nylon brush is not recommended. Flow Regulator should not be remove because it could damage the system 1. 2.
![System with Metal Lever Handleassets.waterworks.com/wasset/25/original/62025.pdf · LEVER HANDLE SET SCREW x 3 2.5mm HEX [LOOSEN ONLY] 1. THERMOSTATIC HANDLE: LIMIT STOP: Unthread](https://static.documents.pub/doc/80x56/607945229c702e6b145ba7c6/system-with-metal-lever-lever-handle-set-screw-x-3-25mm-hex-loosen-only-1-thermostatic.jpg)
