Apple MacBook Pro SSD Installation 15” Retina Models released Late 2013, Mid 2014, Mid 2015

What do I need?

Clear Workspace

New Solid State Drive Torx T5 Screwdriver Pentalobe compatible

screwdriver

To prevent potential damage from anti-static electricity, you should discharge yourself first.

This can be done by simply touching a grounded metal object, such as a radiator.

Installation Process

1 – Make sure the MacBook is

completely shut down and

switched off. Disconnect any

cables.

2 – Turn your MacBook over and

remove the 10 screws that are

securing the bottom case.

Remember where each screw came

from.

3 – Pry the back of the case away

from the MacBook.

8 x 3mm

2 x 2.3mm

Please visit mrmemory.co.uk for guides on cloning your

new SSD. This guide is for physical installation only.

4 – Peel back the warning label

covering the battery connector.

5 – Use the flat end of the spudger

to gently pry the battery connector

from its socket on the logic board.

Bend the battery cables back and

out of the way – ensuring the

battery connector doesn’t

accidentally make contact with the

logic board.

6 – Remove the single 3.1mm T5

Torx screw securing the SSD to the

logic board.

7 – Slightly lift the leftmost side of

the SSD and firmly slide it straight

away out of its socket on the logic

board.

8 – To install your new SSD, repeat

the steps above in reverse order.

Email – support@mrmemory.co.uk

Tel – 01903 692 214