www.liquasil.com www.liquasil.com Liquid Gutter Lining System FOR ASBESTOS, METAL AND CONCRETE GUTTERS Liquasil Limited Unit 3 Radway Industrial Estate, Radway Road, Solihull, West Midlands B90 4NR t 0121 709 5352 e [email protected]w www.liquasil.com February 2019 - Version 4.0 Liquasil Limited - all rights reserved TECHNICAL DATA SHEET Asbestos and Metal Gutters System Reference SWT Corrosion Primer Liquasil One FOR PROFESSIONAL USE ONLY Purpose/Uses Rust and wet tolerant for use Gutter Lining with Liquasil polymers Colour Grey Standard Grey and RAL Colours Range subject to minimum quantities of 100 litres Application Brush or Roller Apply by Brush - Roller Volume Solids 100% 100% Coverage Rate Up to 6m 2 per litre. Presence of heavy rust or Approx 1.25 m 2 per litre use on cast iron will reduce coverage rate Thinners/Brush wash Use Sacrificial Brushes Xylene Weight per Litre 2 kg (Supplied in 0.5 litre tins) 1 kg Flash Point > 100º C Above 32º C V.O.C. V.O.C. Free V.O.C. Free Approvals ABS Certified, IMO Approval, Lloyds Approval BS 476: Part3:1958, Ballast Tank Maintenance Coating Fire and BS 6920 Water Quality Lloyds Type Approval: New Build Applications DIN EN ISO 7783-2 (Bore Steel and Shop Primers) Finish Semi Gloss Semi Gloss Drying Time Allow 6-24 hours drying time Rain free - 2 to 3 hours Thoroughly dry- 16 hours Surface Preparation Remove existing or factory finishes All surfaces must be clean and and prepare to bare metal thoroughly dry, particularly at joints Recommended Film Thickness 100 microns 750 microns Application Temperature 5º C to 40º C (Optimum 15º C to 30º C) -5º C +60º C Considerations Keep tins cool and shaded in summer. Keep tins warm in winter.
Transcript
www.liquasil.comwww.liquasil.com
Liquid Gutter Lining SystemFOR ASBESTOS, METAL AND CONCRETE GUTTERSLiquasil Limited
Unit 3 Radway Industrial Estate, Radway Road, Solihull, West Midlands B90 4NR
• Before continuing, all surfaces to be coated must be bone dry. Ensure that there is no trapped moisture at the joints of the gutter.
• Apply a liberal coat of Liquasil Non-Sag Sealer to all previously treated metalfixingsandtoanysmallholesorcracksthatmightbepresent.
• Using a paint roller or brush, apply a single coat of Liquasil One at a wet filmthicknessof750microns.
• Thoroughly clean the gutter, removing any existing, unstable finishesandpreviouspatchrepairs(especiallyatjoints)asfarasreasonably practicable.
• ApplyasinglecoatofLiquasilSWTPrimeratawetfilmthicknessof 100 microns to entire surface to be treated and allow to dry. (SWT Primer can be applied to wet or damp surfaces).
• Before continuing, all surfaces to be coated must be bone dry. Ensure that there is no trapped moisture at the joints of the gutter.
