2
UNLESS OTHERWISE SPECIFIED DIM. TOLERANCES ARE AS FOLLOWS: X XX XXX XXXX INCH .1 .02 .005 .0005 mm 0.5 0.13 0.013 ANG. .50 DEG REMOVE BURRS & BREAK SHARP EDGES: INCH .003 - .015 mm 0.1 - 0.4 CORNER FILLETS TO : INCH .020 mm 0.5 MACHINE SURFACES : INCH 125 mm METRIC DIMS. SHOWN IN [BRACKETS] A B C D D 1 2 3 C 4 5 6 7 8 B A 1 2 3 4 5 6 7 8 APPD REV BY DESCRIPTION DATE REV DATE FLATNESS STRAIGHTNESS ANGULARITY PERPENDICULARITY (SQUARENESS) PARALLELISM ROUNDNESS (CIRCULARITY) CYLINDRICITY PROFILE OF ANY SURFACE PROFILE OF ANY LINE RUNOUT TRUE POSITION CONCENTRICITY SYMMETRY CONFIDENTIAL : THIS DRAWING AND ITS INFORMATION ARE THE EXCLUSIVE AND CONFIDENTIAL PROPERTY OF AIRBASE INDUSTRIES AND ARE NOT TO BE DISCLOSED,DUPLICATED, DISTRIBUTED OR OTHERWISE USED WITHOUT THE WRITTEN CONSENT OF AIRBASE INDUSRTRIES. - ALL RIGHTS RESERVED. DR BY: APPD: DR BY DATE: APPD DATE: THIRD ANGLE PROJECTION EDS DATE FORMAT REV DESCRIPTION SIZE DWG NO GEOMETRIC CHARACTERISTICS & SYMBOLS SHEET ASME Y14.5 1994 1000 CASS DR CLAYTON, OHIO 45315 A SW 1 2 3 4 5 6 7 8 9 10 11 12 10 13 14 22 23 27 25 26 24 32 30 29 33 36 37 38 31 35 34 39 40 41 45 46 47 49 48 50 51 52 52 53 54 56 57 58 59 60 61 38 40 41 83 42 43 44 45 48 49 46 47 82 50 51 83 52 37 36 35 34 32 30 31 29 33 28 24 27 25 26 65 64 63 62 25 26 66 21 20 18 19 17 16 15 67 24 68 69 70 71 33 34 35 72 73 61 90 40 41 88 74 75 76 77 78 79 80 81 51 50 82 84 85 86 87 28 42 44 43 55 A XX XX-XX XXXX xx-xx- A.W. CAIN 10-27-2014 10-27-2014 D EC20T EXPLODED 1 OF 2 XXXXXX
