When you have completed this module, you wil l be able to:
1. Within a one hour time limit, complete a written exam and a lab exercise without the aid
of a key.
Competency Tests
The AutoCAD Self-paced Learning Modules are written as competency based modules. What
that means to you as a student is that you have not completed each module until you havemastered it. To master a module, you must prove you understand the material contained in itand complete the lab exercise(s) with 100% accuracy within the specified time limit.
In a Competency Test Module there are multiple choice questions and a comprehensive labexercise to test your mastery of the set of modules you just completed. There is no keysupplied with this module as it is meant to be checked by your instructor. If there are any partsof this module that you have trouble completing you should go back after you complete it andreread the modules containing the information you are having trouble with. If necessary, redothe lab exercise(s) in that module(s).
Students attending this Course in a Classroom Setting
If you are a student completing this course in a classroom setting, your instructor will give you
instructions on what to do after you complete this module.
Students Completing this Course by Correspondence
Complete the following steps:
Step 1 Answer the 10 multiple choice questions on pages 11-2 to 11-3. Record the
answers.
Step 2 Complete Lab Exercise 11-1 on page 11-4.
Step 3 Login into the website www.cadinstructors.com with your name and ID number.In the website, write the online written test for Module 11 - Competency Test No. 2.
It has the same 10 questions that you answered in Step 1.
Step 4 Attach the file AutoCAD 2D Lab 11-1.dwg to the test when you write it. Follow the
prompts when you are writing the test.
Step 5 If you have any problems completing Steps 1 to 4, ask your instructor for help.
6. What command sets the number of sides that AutoCAD uses when it regenerates circlesand arcs?
A) VIEWRESB) REGENC) CIRCLED) ARCE) VIEW
7. What function key toggles AutoSnap?
A) F1B) F2C) F3D) F4E) F5
8. What is the name of the four object snap points located around a circle?
A) Center B) MidpointC) EndpointD) PointsE) Quadrants
9 What does the polar coordinate @10<125 mean?
A) From the last point, go 12.5 units at an angle of negative 10 degreesB) From the last point, go 10 units at an angle of negative 125 degreesC) From the last point, go 125 units at an angle of positive 10 degreesD) From the last point, go 10 units at an angle of positive 125 degreesE) From the last point, go 125 units at an angle of negative 10 degrees
10. What polar coordinate would draw the same angle as @5<225?
Note: Color, Linetype, and Lineweight are all < ByLayer < unless otherwise instructed.
Layering Scheme
Objects on Layer Name Color Linetype Lineweight
Construction Objects
All Objects
Instructions:
Construction
Object
253
Red
Continuous N/A
Continuous N/A
1. Setup the layers using the Layering Scheme shown above.2. Draw the object shown below using the layering scheme above.3. Draw all construction objects on layer Construction.4. Turn layer Key off and freeze layer Construction.
