Date post: | 04-Apr-2018 |
Category: |
Documents |
Upload: | junaid-rizvi |
View: | 250 times |
Download: | 0 times |
of 14
7/31/2019 AutoCAD Ppt Final
1/14
7/31/2019 AutoCAD Ppt Final
2/14
INTRODUCTION
Group Members:
Syed Junaid Hassan Rizvi 2k11-EPE-328
Munawar Hussain 2k11-EPE-319
Sajjad Ahmed 2k11-EPE-318
Hammid Malik 2k11-EPE-338
7/31/2019 AutoCAD Ppt Final
3/14
Allama Iqbals TombSteps: First of all we draw a rectangle using "line"; 96-inch wide and 48-
inch long.
For making stairs, use "offset" command, and we have four stairs.Made boundary for each stair using "boundary" command and thenextruded each, to get a 3-dimensional view.
Each stair is of height of 1-foot.
7/31/2019 AutoCAD Ppt Final
4/14
Each stair is of1-foot.
We use extrude command to see 3D view
of stairs.
7/31/2019 AutoCAD Ppt Final
5/14
Then we select OSNAP and move 100units along negative x-axis and 250
units along y-axis then 496 units along
x-axis. In this way a base for Tomb is formed.
Then we select the boundary
command for base and extrude it atheight of 48.
7/31/2019 AutoCAD Ppt Final
6/14
7/31/2019 AutoCAD Ppt Final
7/14
2nd Step
First we use boundry cmd to select boundry; Use extrude cmd: to extrude the recangle. 3D.
elevated part on which tomb was placed. and
extrude it to a height of 48-feets.
Use"elevation" command to elevate the surface of
drawing to height of 48-feet . and made a rectangle
for tomb having dimensions of (180",120").
7/31/2019 AutoCAD Ppt Final
8/14
Use Elevation command.
Select ortho cmd { to make a
rectangle on above surface}After this we use extrude :
7/31/2019 AutoCAD Ppt Final
9/14
3rd Step
Layer command:
Offset:
Boundary:
Extrude command:
7/31/2019 AutoCAD Ppt Final
10/14
7/31/2019 AutoCAD Ppt Final
11/14
To make a Door:
We use these commands: Line command
Arc command
Extrude command
Subtract command
7/31/2019 AutoCAD Ppt Final
12/14
To make the door, first we use front side of
the diagram.
Then use a line command to make a
rectangle.
Then we use offset command on the upper
line of a rectangle.
Then use arc command to make the round-door shape.
7/31/2019 AutoCAD Ppt Final
13/14
Final Step:
To make top portion of tomb. To draw a recangle using following cmd: elevation cmd. 1- ortho cmd
2- osnap cmd 3-offset cmd 4- extrude cmd.
7/31/2019 AutoCAD Ppt Final
14/14