Date post: | 09-Oct-2015 |
Category: |
Documents |
Upload: | lucas-roberson |
View: | 31 times |
Download: | 1 times |
of 26
Lab23 - Configuring Embedded File System
Take a back up of the current IP office and testing configuration backup files works
Select Save Configuration as
Enter a name for the backup configuration file
System failed to load config as it has been erased
Select File - Offline - Open file
password=password
Keep an eye on any digital sets that are plug in - Once set initializes the system is ready!
Check IP address and version - Ensure its correct
Enter password=Administrator
Check that all data configurations are back
Memory SD card - Shutdown
Take a look at the rear of IP Office Control unit - SD LED indication should be OFF
Remove SD card
To re-create SD crad
Using a SD card reader - Insert A-Law SD card(Please ALERT Instructor before doing this)
Select the following:
After about 1 minute and 30 sec, this screen appears
DO NOT REMOVE SD CRAD AT THIS TIME, PLEASE SEE PROGRESS
INDICATOR
Select OK - System SD card successfully rcreated
Formatting SD Card - This will erase the SD card COMPLETLY
Backup All recorded announcements from Embedded File System - DYNAMIC-
LVMAIL - AAG
The screen does show any updates - Please wait.....................................
The SD card is completely ERASED
Wait for this screen to appear approx = 40 sec
Wait for SD card to complete - See progress Indicator
Select OK
Check SD card from my computer
Insert SD card to rear of Control unit
Check the rear of control unit that SD LED is ON
Restore all recordings and reboot IP Office
Test announcements from AA
Performing a system reboot
Lookout on any connected Digital stations - It will be disconnected
Once DS initializes IP office is ready to be login again