Axle Temperature ControlAxle Temperature ControlProduct Design SpecificationProduct Design Specification
Design TeamDesign TeamMike ErwinEmery Frey
Boun SinvongsaLee Zimmerman
PSU Faculty Advisor
Dr. Lemmy Meekisho
Daimler Industry Advisor
Dave Ruuhela
OverviewOverview
►Project BackgroundProject Background►Mission StatementMission Statement►Customer IdentificationCustomer Identification►PDSPDS►House of QualityHouse of Quality►ConclusionConclusion
Project BackgroundProject Background
►2.25% of energy required to operate a 2.25% of energy required to operate a truck is lost in the drive train (fully truck is lost in the drive train (fully loaded, level road, 1 hour)loaded, level road, 1 hour)
►Energy loss can be reduced by heating Energy loss can be reduced by heating the axle lubricant the axle lubricant
►DTNA expects a 1% improvement in DTNA expects a 1% improvement in overall efficiency (approximately overall efficiency (approximately $800/year for each truck)$800/year for each truck)
Mission StatementMission Statement►Design and build a device to achieve Design and build a device to achieve
and maintain specified axle lubricant and maintain specified axle lubricant temperature range. (65-80 °C, 2 temperature range. (65-80 °C, 2 °C/minute) °C/minute)
►Deliverables:Deliverables: Working PrototypeWorking Prototype Detail DrawingsDetail Drawings Bill Of MaterialsBill Of Materials Detailed Design ReportDetailed Design Report
Customer IdentificationCustomer Identification
►Primary External Customer:Primary External Customer: Daimler Trucks North America (DTNA)Daimler Trucks North America (DTNA)
►Primary Internal Customer:Primary Internal Customer: PSU (ME 492/493)PSU (ME 492/493)
Product Design Specification Product Design Specification
High PrioritiesHigh Priorities►Device is to maintain a temperature Device is to maintain a temperature
range of 65-80 °Crange of 65-80 °C►Device must show an ROI within 2yrsDevice must show an ROI within 2yrs►Device must improve net efficiency of Device must improve net efficiency of
vehicle enough to satisfy ROIvehicle enough to satisfy ROI►Device is to heat at a rate of 2 °C/minDevice is to heat at a rate of 2 °C/min
PDS Continued…PDS Continued…
►Device must weigh less than 20 lbs. Device must weigh less than 20 lbs.
►Device should be easily retrofittedDevice should be easily retrofitted
►Device must comply with safety Device must comply with safety regulationsregulations
►Device must be relatively low Device must be relatively low maintenancemaintenance
House of QualityHouse of Quality
ConclusionConclusion
►The deliverables of this project will The deliverables of this project will serve as a starting point for further serve as a starting point for further development by Daimler.development by Daimler.
►There is a potential for a significant There is a potential for a significant increase in efficiency.increase in efficiency.
►Application will ultimately benefit the Application will ultimately benefit the environment and reduce oil environment and reduce oil dependency.dependency.
Questions?Questions?