Before commencing assembly, please read these instructions thoroughly!
PRINTED IN JAPAN 64271010-2
*SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
htpp://www.kyosho.com
© 2010 KYOSHO / KFW006
for KF01INSTRUCTION SHEET
No.KFW006
Thank you for purchasing this product. Before installation, please carefully read and follow the instructions on this sheetin conjunction with the instruction manual of your kit.
Firmly tighten the set screws onto the �at spot.
Ball Diff . Set
Symbols used throughout the instruction manual, comprise:
Apply grease. Apply threadlocker (screw cement).Must be purchased separately!
Assemble in the specified order.
1/8
8
Diff Ball
1/8Diff Ball
Note the direction
Diff Washer
1
4.8x10mm
5mm
Thrust Bearing
4.8x10mmThrust Bearing
1
Taper Washer
Taper Washer
2
6x10mmBearing
6x10mmBearing
6x10mmBearing
1
5x10mmBearing
5x10mmBearing
1
4x 4mm
4x 4mm
Set Screw
Too loose Diff slips.(Power loss) Tighten
Ideal Diff dosen't slip.(Smooth)
Too tight Diff dosen't work. Loosen
To find the appropriate ball diff setting, make small adjustments and check by running the car. Please also refer to the below chart.
Ball diff can be adjusted by tightening or loosening the wheel nut.
SPARE PARTS
Set Screw(M4x4/10pcs)
Shield Bearing(5x10x4)4Pcs
Shield Bearing(6x10x3)2Pcs
Ball Diff. Shaft
Thrust Bearing(4.8x10x4)1Pcs
Diff. Ball(1/8 Inch/10Pcs/SPADA09)
Thrust Diff. Ring(2Pcs/TF-5)