Date post: | 15-Apr-2017 |
Category: |
Self Improvement |
Upload: | bigaltrading |
View: | 218 times |
Download: | 0 times |
D.I.Y KIT
GARAGE DOOR FLOOR SEAL
Stops water and dust from blowing under your garage
doorWe all know that its very difficult to get a garaged floor level , and that leads to water
coming in under the door, dust blows in and it is a endless battle to keep the floor clean, dry and safe.
The garage door seal comes in three sizes:2,6 m Single Garage door and 5,1 Double Garage door
PM on request
2.6 Single Garage door 5.1 Double Garage door
Normally: A single garage door standard size is 2.5m and a double garage is 5mAs a precautionary measure we included a 100mm extra on each strip, just incase the garage door is not 100 % standard
Installation is Easy
All you need
1. DIY KIT2. Benzene Thinners or same as
3. Marking Pencil4. Masking Tape5. Hair Dryer or Heat Gun6. Silicon / Glue Gun7. Old Cloth
This is not always the case, but if the strip has a crinkle cut look you need to do this
The rolled up floor seal may have a memory, roll it out flat ON CLEAN SURFACE heat
gradually with a hairdryer or heat gun, until it is completely flat.
Allow to cool.(a roller may be used to roll the raised edges while heating with a hairdryer, ensure not to overheat the strip)
Measure the strip on either ends of the door, Mark the Strip, then cut to fit.
NB: Do Not cut to much off
Close the garage door. Push the door seal under the garage door from the inside so the door seal ridge is up against the back of the garage door.
Using a soft pencil, mark the floor on both sides of the floor seal so that when you remove it you know where to stick the masking tape.
Place masking tape on either sideof pencil lines. So you have guide lines for when applying the adhesive.
Clean and dry the area where you plan to install the door seal.
All dirt, water, mud, oil and other debris must be removed. Wiping the area with benzene or alcohol will ensure a clean bonding surface.
NB! Use personal protective equipment when using chemicals i.e. gloves, mask, glasses etc.
Apply the adhesive to the floor between the lines, in eitherstraight or zigzag.
This step is very important
Press the strip onto the adhesive starting at one end, slowly forcing out air bubbles as you press the strip down, get someone to hold the long piece up away from the adhesive.
Run a bead of adhesive along the edge of the door seal. Use your finger or a cloth with soapy water so you can smooth out the adhesive before it starts setting. (add adhesive on sides if its needed to ensure sides have been sealed)
Remove the masking tape before the adhesive sets.
FINAL LOOK
View from the inside
As easy as that!!!NB! Don’t drive over the strip for 24 hours
This is truly an
amazing product, and will make your life easier
Unit 5 GPRS Industrial Park Old Main Road Park Ryne Po Box 2065Clansthal4170
Cell : 084 945 5423
Tel : 039 976 1271Fax : 086 652 6215
Email [email protected] Web www.bigaltrading.co.za
Contact details: