BMW ISID for real ICOM configuration
manual
Note:
Minimum Computer Hardware Config: Dual Core 2.0G CPU/ 4G RAM/250G
HardDisk/ Win xp SP3 professional or 7 64bit Ultimate version
Recommend Computer Hardware Config: Intel I3 or I5 CPU/8G RAM/250G
7200RPM Harddisk/ Win 7 64bit Ultimate Version
1. Copy the ISID all files to Harddisk, Unpack ISID from archives.
2. Install VMware Workstation 8, run and select Virtual Network Editor.
3. Configure network exactlly as on picture. At green ellipse marked place
for VMnet0 select network adapter which will be used for connection with
www.obd2express.co.uk
ICOM
4. Open ISID virtual machine. If you have Win x64 and host RAM more then
4Gb, then you can set ISID memory size from 1536Mb to 2048Mb. ISSS can
process Exx with 2048Mb instead of 4096Mb, but will show you warnings.
Don't use other values since this will cause failures.
www.obd2express.co.uk
5. Open VM properties and check Network Adapter set to VMnet2, close and
boot.
www.obd2express.co.uk
6. When asked, select "I moved it".
www.obd2express.co.uk
7. Wait until VM boots and ISTA icon gets active.
8. Connect ICOM using network cable to PC, then connect ICOM to car, wait
about minute or two.
www.obd2express.co.uk
9. Click right mouse button over connection icon on the right bottom VM
window corner and select "Settings...".
www.obd2express.co.uk
10. Change Network connection type to "Bridged" then press "Ok".
11. Connection icon will change to inactive state and after some time
gets back to active. Wait 1-2 minutes, then start ISTA via one-double
www.obd2express.co.uk
left mouse button click over ISTA-D or ISTA-P icon in WSM interface.
www.obd2express.co.uk
12. For ISID select "Identification", for ISSS select "Create new
session".
www.obd2express.co.uk
13. Next for ISID click on "Read out vehicle data" then "Ok", for ISSS
click "Continue".
www.obd2express.co.uk
14. After some time in ISID or ISSS "Connection manager" list should
appear your ICOM. Select it and press "Set up connection" or "Connect".
Note: By default supported only chinese clone ICOM with corresponding
firmware version.
www.obd2express.co.uk