Date post: | 14-Feb-2017 |
Category: |
Engineering |
Upload: | selva-prakash |
View: | 38 times |
Download: | 0 times |
By selvaprakash
general• Chemistry :Chemistry :The strength with which a chemical
bond holds two atoms together; conventionally measured in terms of the amount of energy, in kilocalories per mole, required to break the bond.
• Engineering Engineering :: The amount of adhesion between bonded surfaces measured in terms of the stress required to separate a layer of material from the base to which it is bonded
definition
• The resistance to separation of mortar and concrete from reinforcing steel (or other materials) with which it is in contact.
• Forces that resist separation, such as adhesion, friction.
classification
• It Consider Two AnglesIt Consider Two Angles
• The bond strength between paste and steel reinforcement
• The bond strength between paste and aggregate.
bond strength between paste and steel reinforcement
• A perfect bond, existing between concrete and steel reinforcement is one of the fundamental assumptions of reinforced concrete
• Bond strength arises primarily from the friction and adhesion between concrete and steel.
Factors influencing bond strength
• Roughness of the steel
• specific surface of gel
• High pressure steam curing
the bond strength between paste and aggregate.
• Concrete can be regarded as a chain in which aggregates are the links bonded together by cement paste
• The strength of concrete as a whole is depending upon the strength (bond strength) of the hydrated hardened cement paste (hcp)
• Strength of hcp is depending upon w/c ratio and the products of hydration in particular the C-S-H gel
Factors influencing
• Transition zone
test
• PurposeThe BOND-TEST is used to conduct a pull-off test in accordance with ASTM C1583
• PrincipleIn the BOND-TEST, a disc is bonded to a prepared testing surface and the disc is pulled off after a partial core has been cut around the disc
procedure
• Surface planning
• Bonding the disc
• Partial coring
• Pull-off
Surface planning
• The surface is ground with a diamond wheel to
expose the aggregates and to obtain a plane surface.
The centre knob is removed with a separate grinder.
The dry surface is steel brushed and any dust or
powder is blown away. The suction plate is used to
control the planing operation.
Surface planning
Bonding the disc
• A clean disc is bonded to the prepared surface using a rapid-curing adhesive (GRA). The GRA adhesive has a tensile strength of 10 MPa when fully cured, which takes 2 to 5 minutes at normal temperatures. In cold weather conditions, the concrete surface and the disc are heated with a heat gun to accelerate curing of the adhesive
Bonding the disc
Partial coring
• A partial core is cut perpendicular to the surface; the bonded disc serves as a drill guide (the inner diameter of the coring bit is slightly larger than the disc diameter). The partial core is cut with the CORECASE For tests to measure bond strength, the core is cut to a depth of 25 mm or one-half of the core diameter, whichever is greater;
Partial coring
Pull-off
• The disc is loaded in direct tension at a controlled rate using a calibrated hydraulic pull machine. The machine bears against a circular counter pressure ring positioned centrally on the planed surface. The peak force in kN is recorded and used to obtain the pull-off strength by dividing by the cross-sectional area of the partial core. The type of failure
Pull-off
Testing examples