+ All Categories
Home > Documents > boosterplug installation triumph tiger 800 · • Lift the rear end of the tank - make sure you...

boosterplug installation triumph tiger 800 · • Lift the rear end of the tank - make sure you...

Date post: 29-Aug-2018
Category:
Upload: buianh
View: 233 times
Download: 0 times
Share this document with a friend
1
Installation Model specific instructions These instructions are a model specific add-on to the general BoosterPlug installation instructions. The general BoosterPlug installation instructions can be found in the “Downloads” section on the BoosterPlug.com website: http://www.boosterplug.com/shop/cms-downloads.html For: Triumph Tiger 800 (2010-2014) Triumph Tiger 800 XC (2010-2014) Triumph Tiger 800 XR/XRx/XRt (2015 and up) Triumph Tiger 800 XC/XCx/XCa (2015 and up) Installation Tips Install the BoosterPlug module as per the general installation papers. The pictures below should help you locate the AIT sensor where the BoosterPlug is installed. Remove the seat (Yellow circle - Picture 1) Remove lower plastic covers on both sides (Yellow circle - Picture 2) Loosen upper plastic covers on both sides no need to remove them completely.(Yellow circle - Picture 2) Lift the rear end of the tank - make sure you dont scratch the tank against the upper plastic covers - protect the tank with a clean rag (Yellow circle - Picture 3) The red circle will show you the location of the AIT sensor Pictures
Transcript

Installation Model specific instructions

These instructions are a model specific add-on to the general BoosterPlug installation instructions. The general BoosterPlug installation instructions can be found in the “Downloads” section on the BoosterPlug.com website: http://www.boosterplug.com/shop/cms-downloads.html

For:

• Triumph Tiger 800 (2010-2014)

• Triumph Tiger 800 XC (2010-2014)

• Triumph Tiger 800 XR/XRx/XRt (2015 and up)

• Triumph Tiger 800 XC/XCx/XCa (2015 and up)

Installation Tips • Install the BoosterPlug module as per the general installation papers.

• The pictures below should help you locate the AIT sensor where the BoosterPlug is installed.

• Remove the seat (Yellow circle - Picture 1)

• Remove lower plastic covers on both sides (Yellow circle - Picture 2)

• Loosen upper plastic covers on both sides no need to remove them completely.(Yellow circle - Picture 2)

• Lift the rear end of the tank - make sure you dont scratch the tank against the upper plastic covers - protect the tank with a clean

rag (Yellow circle - Picture 3)

• The red circle will show you the location of the AIT sensor

Pictures

Recommended