+ All Categories
Home > Documents > BORON Chemistry - Amazon S3 · Chemistry Boron BORON Background Boron (B) is essential for crop...

BORON Chemistry - Amazon S3 · Chemistry Boron BORON Background Boron (B) is essential for crop...

Date post: 16-Jun-2019
Category:
Upload: dothuan
View: 259 times
Download: 4 times
Share this document with a friend
2
Chemistry Boron BORON Background Boron (B) is essential for crop growth and development but in very small quantities. While the precise role of boron in plants is not fully known there is evidence to show that boron is important for cell division, the production of nucleic acids (DNA, RNA), the movement of sugars across membranes and the development of reproductive structures (i.e. pollen tubes, fruit, grain). Deficiencies For most crops, 1–4 mg-B/kg soil is sufficient to prevent nutrient deficiencies. Less than 0.5 mg-B/kg is rated as marginal to deficient. Boron is generally present in soils as B 4 O 7 2- , H 2 BO 3- , HBO 3 2- and BO 3 3- . Each of these ionic forms are readily leached under high rainfall conditions. Acid deep sands in higher rainfall regions (>600 mm) where there is little clay and organic matter within the root zone are at most risk of having low boron levels. Symptoms of boron deficiency vary between plants ranging from hollow cavities in vegetable crops, distorted growing tips, discoloration and a ‘corky’ appearance in fruit and flower and pod abortion in canola. Symptoms are most noticeable in actively growing sites. A map of potentially boron deficient soils in Western Australia is given in figure 1. Deficiencies are more likely to occur where high biomass crops encounter low soil moisture conditions. While boron deficiencies in WA are generally rare, the condition can be over come with Borax (11% B) top dressed at 3 kg/ha or Solubor (21% B) applied as a foliar spray at 1% (weight/volume). The total amount of elemental Boron applied should not exceed 0.5 kg/ha. Uneven applications of boron can lead to toxicity. Time of application is important and is best from anthesis through to flowering. Toxicity Boron toxicity in Australia is mainly confined to the low rainfall (<550 mm/yr) Mallee vegetation communities of Western Australia, South Australia and Victoria. The soils typically contain highly alkaline (pH>8) and sodic clay subsoils which are poorly leached and have boron concentrations >12 mg-B/kg of soil. Often boron toxic soils have formed from marine sediments or boron rich minerals including tourmaline. Symptoms of boron toxicity in barley are chlorotic and necrotic lesions in older leaves where as in wheat there are few visual symptoms. Soils with potentially high levels of boron in WA are shown in figure 2. Key points Boron is essential for plant growth, but only needed in very small amounts. Soils deficient in boron are often deep sands in high rainfall zones. Toxic levels of boron tend to be found in the heavier soils of the Mallee regions. Boron toxicity is best managed through the use of crops that exhibit tolerance to the nutrient. Measured soil B Measured B, approx. loc. Risk of B deficiency Deficient Deficient Sufficient Sufficient Above average Average Below average Low Figure 1: Areas within south-western Australia cropping region believed to be at risk of boron deficiency based on surface geology, topsoil pH and clay content (adapted from Wong et al, 2005). Geraldton Bunbury Perth Augusta Albany Esperance Boron toxicity risk >50% 25–49% 0–24% 300 mm 600 mm Figure 2: Areas in Western Australian cropping region prone to boron toxicity.
Transcript

Chem

istry

Boro

n

BORON

BackgroundBoron (B) is essential for crop growth and development but in very small quantities. While the precise role of boron in plants is not fully known there is evidence to show that boron is important for cell division, the production of nucleic acids (DNA, RNA), the movement of sugars across membranes and the development of reproductive structures (i.e. pollen tubes, fruit, grain).

DeficienciesFor most crops, 1–4 mg-B/kg soil is sufficient to prevent nutrient deficiencies. Less than 0.5 mg-B/kg is rated as marginal to deficient. Boron is generally present in soils as B4O72-, H2BO3-, HBO32- and BO33-. Each of these ionic forms are readily leached under high rainfall conditions. Acid deep sands in higher rainfall regions (>600 mm) where there is little clay and organic matter within the root zone are at most risk of having low boron levels. Symptoms of boron deficiency vary between plants ranging from hollow cavities in vegetable crops, distorted growing tips, discoloration and a ‘corky’ appearance in fruit and flower and pod abortion in canola. Symptoms are most noticeable in actively growing sites. A map of potentially boron deficient soils in Western Australia is given in figure 1.

Deficiencies are more likely to occur where high biomass crops encounter low soil moisture conditions.

While boron deficiencies in WA are generally rare, the condition can be over come with Borax (11% B) top dressed at 3 kg/ha or Solubor (21% B) applied as a foliar spray at 1% (weight/volume). The total amount of elemental Boron applied should not exceed 0.5 kg/ha. Uneven applications of boron can lead to toxicity. Time of application is important and is best from anthesis through to flowering.

ToxicityBoron toxicity in Australia is mainly confined to the low rainfall (<550 mm/yr) Mallee vegetation communities of Western Australia, South Australia and Victoria. The soils typically contain highly alkaline (pH>8) and sodic clay subsoils which are poorly leached and have boron concentrations >12 mg-B/kg of soil. Often boron toxic soils have formed from marine sediments or boron rich minerals including tourmaline. Symptoms of boron toxicity in barley are chlorotic and necrotic lesions in older leaves where as in wheat there are few visual symptoms. Soils with potentially high levels of boron in WA are shown in figure 2.

Key points Boron is essential for plant growth, but only needed in very small amounts.

Soils deficient in boron are often deep sands in high rainfall zones.

Toxic levels of boron tend to be found in the heavier soils of the Mallee regions.

Boron toxicity is best managed through the use of crops that exhibit tolerance to the nutrient.

Measured soil B

Measured B, approx. loc.

Risk of B deficiency

Deficient

Deficient

Sufficient

Sufficient

Above averageAverageBelow averageLow

Figure 1: Areas within south-western Australia cropping region believed to be at risk of boron deficiency based on surface geology, topsoil pH and clay content (adapted from Wong et al, 2005).

Geraldton

Bunbury

Perth

Augusta

Albany

Esperance

Boron toxicity risk>50%25–49%0–24%

300 mm600 mm

Figure 2: Areas in Western Australian cropping region prone to boron toxicity.

This soilquality.org.au fact-sheet has been funded by the Healthy Soils for Sustainable Farms programme, an initiative of the Australian Government’s Natural Heritage Trust in partnership with the GRDC, and the WA NRM regions of Avon Catchment Council and South Coast NRM, through National Action Plan for Salinity and Water Quality and National Landcare Programme investments of the WA and Australian Governments.

The Chief Executive Officer of the Department of Agriculture and Food, The State of Western Australia and The University of Western Australia accept no liability whatsoever by reason of negligence or otherwise arising from the use or release of this information or any part of it.

Boro

n

Boron toxicity is relatively rare compared to boron deficiency and is hard to treat. Managing boron toxicity can be achieved through leaching, the application of amendments and using tolerant varieties. Irrigating to encourage leaching is highly effective. However in the absence of irrigation water, amending soils with gypsum can increase water infiltration in sodic clays and consequently leach boron deeper into the soil. Dryland trials near Esperance have shown high rates of gypsum over 20 years can leach boron approximately 10–20 cm. In some circumstances foliar sprays of zinc have been shown to alleviate boron toxicity, although the interaction between boron and zinc is poorly defined.

Boron testingSoil testing is considered the best method for determining the presence of boron deficiency or toxicity. However due to the high spatial variability in soil boron, testing needs to be done strategically in areas of high and low plant production and throughout the root zone. Due to the mobile characteristics of boron in soil, the most accurate determination of boron status is to sample soil to depth.

Hot water extraction in 0.01 M CaCl2 solution is the recommended method for determining soil boron.

Plant tissue testing is less reliable as critical limits cannot be easily determined due to the uneven accumulation of boron in plant tissues, variation in boron uptake at different growth stages and the leaching of boron from plant tissue during rainfall. Seed testing is seen as a more reliable method for determining potential boron toxicity. Grain with more than 3 mg-B/kg is likely to have been grown in boron toxic soils.

Plant susceptibilityPlant species and varieties differ in their susceptibility to boron deficiencies and toxicities. Specific species tolerances to boron deficiency are given in table 1. In terms of boron toxic soils there appears to be more variation in tolerance within species than between. The cultivars or genotypes that are most susceptible to boron toxicity accumulate boron where as those least susceptible have the ability to exclude boron.

Further reading and referencesDear BS and Weir RG (2004) Boron deficiency in pastures and field crops. AGFACT P1.AC.1. New South Wales Agriculture.Bell RW, Frost K, Wong M and Brennan R (2002) Boron – should we be worried about it? Department of Agriculture and

Food, Western Australia Crop Updates 2002: Farming Systems. (online)Moore GJ (2004) Chapter 6.10 Boron. Soilguide Bulletin 4343 Western Australian Department of Agriculture.Nable RO, Bañuelos GS and Paull JG (1997) Boron Toxicity. Plant and Soil 193:181-198. Tisdale SL and Nelson WL (1975) Soil Fertility and Fertilisers (3rd Edition), (Collier MacMillan International Editions:

London).Wong M (2003) Monitor crops closely for signs of low boron. Farming Ahead, March 2003. Wong MTF, Bell RW and Frost K (2005) Mapping boron deficiency risk in soils of South-West Western Australia using a

weight of evidence model. Australian Journal of Soil Research 43: 811-818.

Author: David Hall (Department of Agriculture and Food, Western Australia)

Table 1: Crops and cultivars susceptible to boron deficiency or toxicity.

Susceptible Moderately Susceptible Tolerant

Boron DeficiencyLucerneCanola

Sunflower

CloverMaize

All winter cerealsSorghum

RicePea

Bean

Boron Toxicity Barley (cv. Stirling)Wheat (cv. Binnawarra)

Barley (cv. Skiff)Sunflower (H. tuberosis)

Wheat (cv Halberd)Sunflower (H. annus)


Recommended