BRX210 BRX210 ‘Mechanical ‘Mechanical
Blueprint Reading’Blueprint Reading’Unit #10Unit #10
AnglesAngles
After studying this unit, you After studying this unit, you will be able to:will be able to:
Identify a chamfer and interpret its Identify a chamfer and interpret its sizesize
Define the term ‘taper’ and interpret Define the term ‘taper’ and interpret the meaning of TPF and TPFthe meaning of TPF and TPF
Perform calculations using taper Perform calculations using taper datadata
Define the term ‘bevel’Define the term ‘bevel’ Define the term ‘chamfer’Define the term ‘chamfer’
CHART-DOWEL – SPLIT TYPE QUIZCHART-DOWEL – SPLIT TYPE QUIZ1.1. 40051484005148
2.2. 40051484005148
3.3. .390/.370.390/.370
4.4. 4005149/40058514005149/4005851
5.5. WAS .06/.10WAS .06/.10
6.6. SAE 1010 STEELSAE 1010 STEEL
7.7. +/- 2°+/- 2°
8.8. .20°.20°
9.9. 606606
10.10. GO-NO GO RINGGO-NO GO RING
11.11. NONENONE
12.12. ENGINEERING CHANGE REVISIONENGINEERING CHANGE REVISION
13.13. .004.004
14.14. BECAUSE THE PART HAS A SPLITBECAUSE THE PART HAS A SPLIT
15.15. B (11” x 17”)B (11” x 17”)
16.16. .015.015
17.17. .580.580
18.18. .410.410
19.19. .510.510
20.20. 40053074005307
REAR PRESSURE ROLL SWING LINK QUIZREAR PRESSURE ROLL SWING LINK QUIZ
1. .3162. 2024-T4 ALUM.3. ¼ (.250)4. 25. 5/166. 37. ½8. AUTO. 6409. CONTOUR CHANGE10.+/- .00211..106512.5/1613.FJS14.+/- ½°15.YES16.640-030117.45°18.1/819.220.45°
TAPERED RIVET QUIZTAPERED RIVET QUIZ
1. 1.1652. .375/.3653. .365/.140/.0524. +/- .0055. .1806. .4167. .0068. 3:19. BILATERAL10..1211.NONE12..035 TPI13.1018 STEEL14.15–1/2°15..060/.052