Business Enabled Communications

System Features

Contents• System Feature

• System Specific Items• USB Usage• SMDR Mailing Service & Changed Admin-Set• LED Flashing Control• Dummy Dial Tone Service• Executive / Secretary• PPTP Remote Access• Green Mode

• Tone & Ring• Tone – Organization• Ring – Organization

• Board Setting• ISDN, VOI, & VMI Board Attribute

- There are one USB port supported in MPB Board

- Through USB port, administrator can download system DB and also upload DB file manually.

- Also administrator can assign auto download DB file whenever they want time.

- Through USB port, administrator can upgrade MPB S/W.

DB Up/Download Manually at Attendant Keyset 1. Install USB Stick to MPB USB slot. 2. DB Download : [Tran/PGM] + ‘0’ + ‘9’ + ‘2’ 3. DB Upload : [Tran/PGM] + ‘0’ + ‘9’ + ‘3’

S/W Upgrade at Attendant Keyset 1. Install USB Stick to MPB USB slot. 2. SW Upgrade : [Tran/PGM] + ‘0’ + ‘9’ + ‘1’

DB Download Automatically for Backup 1. Install USB Stick to MPB USB slot. 2. Set Auto-Download Time in a day PGM223-Flex9, Flex10.

USB Usage (DB Up/Download & S/W Upgrade with Attendant-Keyset)

System Specific Items

- System automatically send the E-mail to assigned Supervisor for notification about state of SMDR

- Sending E-mail time rule can be defined SMDR Attribute Admin PGM 232.

- And also SMDR data can be attached by Sylk File type. So supervisor can open this file with Excel-Program

Automatically SMDR Notification 1. Set Mail-Sending Time PGM 232 2. Daily or Weekly sending rule can be assigned 3. When assigned time, system send E-mail

SMDR Mailing Service

System Specific Items

SMDR Attribute PGM232

Example SMDR Mail

Mail Server Address&

User Address

Sender Addr is used for Mail Sender Address

Weekly or Daily Set

SMDR Mailing Service (WEB-Admin)

System Specific Items

- SMDR Service Option : [On Line] / [Off Line] / [On-Off Line] / [Interface] / [E-Mail] / [Off Line & E-Mail] / [On-Off Line & E-Mail] / [Interface & E-Mail]

- Report Type [Outgoing Call] / [Incoming Call] [Internal Call] / [Lost Call]

- Additional Report Option 1. Transfer Call Charge 2. Attendant Transfer Call Charge

Changed SMDR Admin-Set

System Specific Items

- Administrator can control and reassign all kinds LED Flashing rule at PGM234.

- Administrator can change Flashing Color and Flashing Rate.

- MG system support 48 kinds of Flashing Type and has default flashing rule just like ipLDK series.

LED Flashing PGM234

LED Flashing Control

System Specific Items

- During Intercom Busy, caller can make One-Digit Service.- Administrator can define One-Digit Service as Step-Call or Other-features.

One-Digit Service 1) Step-Call Service 2) Call-Back, Call-Wait, Camp-On, Voice-Over, Intrusion, Pilot-Hunt

Intercom Busy Digit PGM237

STEP Call Service

One Digit Service Call-Back Call-Wait Camp-On Voice-Over Intrusion Pilot-Hunt

Intercom-Busy One Digit Service

System Specific Items

- When digit conversion is programmed, the CO line is seized after digit conversion is completed.

- With a Dial Tone Digit Service, dummy dial tone can be provided. although before CO line is not seized actually by user.

1. Make Outgoing Grouping CO line 1. LCO Line is Outgoing CO Group 1 2. PRI Line is Outgoing CO Group 2

Ex Site Situation : 1) PRI start from ‘1’ , all of other dial number is not matter. 2) Common CO & LCO CO Board is used in that Site.3) Administrator want to make user seize PRI CO, if outgoing dial number start from ‘1’ for charging.4) Without number Seize Dial Number is ‘9’

Dial Tone Digit Table

System Specific Items

2. Make Digit Conversion number from ‘91’ to ‘802’ 1. Set the digit conversion rule at Digit-Conv. Table.

3. Assign Dummy Dial Number ‘9’ 1. Assign Digit number ‘9’ for Dummy Dial Tone at Dummy Dial-Tone Digit Table.

4. When User press dial ‘9’, then user always can hear Dummy-Dial Tone.

Dial Tone Digit Table

System Specific Items

- MG System support two-type of Executive/Secretary Service. 1) with DN Numbering Scheme 2) with Assignment Executive/Secretary Scheme.

- In Executive/Secretary Assignment table, Max 48 rules can be supported.- Each Executive can has 3 Secretaries, and also ICM/CO call answer rules can be defined.- all Executives can have the authority to access between other Executives.

Executive/Secretary Assignment PGM241

ICM call Rule Co call Rule

Executive Call Case Secretary Call Choice

Executive / Secretary

System Specific Items

- MG System support Remote access Method from other network area by PPTP.

- Administrator can make 4 PPTP rules to access from public outside area.

Private Network Zone

Internet

Private IP192.168.10.1

Private IP192.168.10.2

Public IP123.123.123.5 Public IP

15.15.32.56

- Outside PC can not access to MG system with only IP 192.168.10.1 - 2

In that case, if PPTP function is set, MG system try to make PPTP connection to outside PC. And then tunneling connection will be established between PC and MG system.After connection outside PC user can control MG system by Web Admin

PPTP Access System from Remote PC

System Specific Items

PPTP Connection Request1. By ATD(PGM+0+8+4)PPTP Connection2. By CLI(PPTP Service CLI)

- MG System can disable the power of a Digital Phone or SLT installed in the DTIB/SLIB/DSIU at night or during holiday mode.

-The power On/Off can be controlled by Web Admin manually or automatically according to the assigned power On/Off time.

- Green mode applied Board : DTIB 12/24, SLIB 12/24

DKTs in 1st DTIB Board

Can be power off during Night

DKTs in 2nd DTIB Board

Can not be used Power Save

SLTs in SLIB Board Can be assigned

power off rule only during holiday

Administrator can assign each board to off power defined Time

Green Mode (Power Saving)

System Specific Items

Green Mode Activation (Only Web-Admin)

Administrator can assign each board individually

Manual Power On/Off Button

Green Mode Time Setting (Only Web-Admin)

Administrator can assign Power Off Start Time and Power On Start Time.

These time rule can be defined by day of the week.

Green Mode (Power Saving, WEB-Admin)

System Specific Items

- All kinds of Tone and Ring can be changed by Web-Admin.

- Tone information is described as Tone-Table and all cases of Tone is defined at PGM 290.

- Ring information is described as Ring-Table and all cases of Ring is defined at PGM 265.

Tone-Table PGM 290

Ring-Table PGM 265

MG Tone & Ring

- 74 kinds of Tones in a table are defined.

- Each Tone has 14 kinds of Tone-Type. ( Normal , Prompt, Announcement, Int-MOH, Ext-MOH, 4-VMIB MOH, 5-SLT MOH )

- Each Tone will be played during assigned Tone-Time.

- If Tone Type is Prompt or Announcement, recorded message will be played at Prompt/Annc. No.- If Tone Type is VMIB or SLT MOH, assigned MOH will be played at Music Source Admin PGM 229.- If Tone Type is Normal, assigned Tone Port(Tone Source) will be played. This Tone Port(Tone Source) is defined at Tone Frequency/Cadence Table PGM 264.

Tone-Table PGM290 Tone Type

Tone – Organization (Tone Table)

Tone & Ring

- Internal MOH and VMIB MOH and SLT MOH can be assigned at Music Source Admin PGM229.

- In case of Internal MOH, system can support 13 fixed Music. - In case of VMIB MOH, MAX 4 MOH channel can be supported. But Each VMIB /AAIB board only have one MOH. - In case of SLT MOH, any SLT port can be assigned for SLT MOH.

Music Source PGM229 Installed VMIB/AAIB Slot will be displayed in order.

Administrator can assign only one Message for MOH per each Board.

Tone – Organization (Music Source)

Tone & Ring

- There are 19 Tone Port(Tone Source) . Each Tone is defined with Frequency and Cadence.- Each Tone Port Frequency can be combined two different Frequency. - Each Tone Port will be played with On/Off Cadence from Cadence info1 to info 4.

Tone-Frequency/Cadence Table PGM264

In case of Tone Port 4 , 425Hz Frequency Tone will be played.

ON Time100msec.

ON Time100msec.

OFF Time400msec.

OFF Time400msec.

425HzFrequency

Tone – Organization (Tone Frequency/Cadence Table)

Tone & Ring

Tone Type

Normal Prompt Announcement

Ex : Error Tone-> applied when user hears error tone

Tone Table support different Tone Type, since MG is able to provide different source to specific Tone. Now we will explain case of Normal case.

MG will provide Error Tone according with setting of Tone Port freq1-2.Since Repeat value for Tone Port is 255 (means continuously), then Tone will operate according with Tone Time (PGM 290). The Error Tone cadence is 300msec ON/200msec OFF repeat.

Tone Type -> Normal Tone Time -> 20s Tone Port -> 1 Used for Cadence

Used for ON/OFF Time Unit

Tone – Organization (Example)

Tone & Ring

- 17 kinds of rings in a table are defined.

- Each Ring has 4 kinds of Ring Index. 1) 4 type Ring Index can be decided by User Program 2) User can define [Trans/PGM] 21 for ICM Differential Ring 3) User can define [Trans/PGM] 22 for CO Differential Ring

- Each Ring will be played during assigned Ring-Time.

- Assigned Ring Index Number (Ring Source) is defined at Ring Frequency/Cadence Table PGM 266.

Ring-Table PGM 265

Ring – Organization (Ring Table)

Tone & Ring

- There are 15 ring Index (Ring Source) . Each Ring is defined with Frequency and Cadence.- This Table format is same as Tone- Frequency/Cadence Table.

Ring-Frequency/Cadence Table PGM266

In case of Ring Index 2 , combined Ring with 1000Hz Frequency and 1020Hz Frequency, will be played.

ON Time400msec.

OFF Time2sec.

1000Hz & 1020HzFrequency Combined

ON Time400msec.

OFF Time2sec.

Ring – Organization (Ring Frequency/Cadence Table)

Tone & Ring

Ex : Intercom Ring-> applied when station gets intercom ring

Ring Table support different Ring Type, since MG is able to provide different source to specific Ring. Now we will explain the ring scheme.

Used for ON/OFF Time Unit

Used for Ring Cadence

Used for ICM Differential Ring.It can be selected by station program (PGM 21)

MG will provide Intercom Ring according with setting of Ring Index freq1-2.Since Repeat value for Ring Index is 255 (means continuously), then Ring will operate according with Ring Time (adm265). When Ring Time expire, the Intercom Ring is stop and caller hears Error Tone.The Intercom Ring cadence is 800msec ON/2.4sec OFF repeat.

Ring – Organization (Example)

Tone & Ring

ISDN Attribute PGM 300

Administrator can define ISDN Data CRC Check

TE / NT Mode

BRI PROT Layer-2 TEI Mode

ISDN Clock Priority PGM 301

Administrator can define ISDN Clock Priority

MG System can control Clock Signaling by Web Admin against LDK system Series

ISDN Board Setting

ISDN, VOI, & VMI Board Attributes

VOIB / VMIB Attribute PGM 305

External Port Board IP Address

IP Board Specific Attributes.

VOIB / VMIB Board Setting

ISDN, VOI, & VMI Board Attributes