Date post: | 15-Feb-2017 |
Category: |
Health & Medicine |
Upload: | sureshpdrn |
View: | 94 times |
Download: | 2 times |
Capnography and
Interpretations
Presenter- Dr. Suresh PradhanModerator- Dr. Nabin Regmi
Respiration
Capnography depicts respiration
Terminology• Capnography: Recording of CO2 concentration
versus time and also its graphic display as a function of time or volume• Capnograph: Machine that generates waveform• Capnometry: Measurement of CO2 in gas
mixture and display in numeric form only• Capnometer: Device that measures and
displays readings• Capnogram: Actual waveform
• Capnography is synonymous with patient safety during anesthesia and sedation, and a boon during CPR• Since the introduction of the first infrared
CO2 measuring and recording apparatus by Luft in 1943, capnography has evolved into an essential component of standard anesthesia monitoring armamentarium
• the primary goal of anesthesiologists is to prevent hypoxia, and capnography helps to identify situations that can lead to hypoxia if uncorrected• also helps in the swift differential diagnosis of
hypoxia before hypoxia leads to irreversible brain damage
• Because of these advantages, the utility of capnography has recently been extended outside of the operating room arena to-
− emergency rooms− endoscopic suites− x-ray rooms− on-site emergency and trauma fields− Sedation in all areas− CPR− Intensive Care Units− Postoperative patients receiving narcotics− Prehospital transport− Interdepartmental transport
• the American Society of Anesthesiologists (ASA) and Association of Anaesthetists of Great Britain and Ireland (AAGBI) require capnography to be used to monitor ventilation during moderate to heavy sedation• the American Heart Association (AHA) recommends
using capnography to judge the effectiveness of chest compression during CPR
• Capnography helps to assess anesthesia equipment, circuits, ventilation perfusion mismatching in the lungs, cardiac output, and metabolism
CO2 waveform during CPR• chest compression for effective CPR should be
optimized so that PETCO2 values are between 10 and 20 mm Hg (>20 mm Hg)• if PETCO2 values, measured after initiation of ACLS,
are less than 10 mm Hg, it is associated with a pooroutcome
• An abrupt increase in PETCO2 may indicate a return of spontaneous circulation(ROSC)
• Increase in pulmonary circulation brings more CO2 into lungs for elimination
Capnography – The Past• The first CO2 analyzer (Godart Capnograph
medical CO2 analyzer) in the Central MilitaryHospital, Utrecht, The Netherlands (1962)
• Prof. Bob Smalhout
Capnogram
Arterial to end-tidal CO2 gradient
• Under normal physiologic conditions, the difference between arterial PCO2 (from ABG)and alveolar PCO2 (EtCO2 from capnograph) is 2 to 5 mmHg• This difference is termed the PaCO2—PEtCO2 gradient
and can be increased in:◦ COPD (causing incomplete alveolar emptying)◦ ARDS (causing V/Q mismatch)◦ A leak in the sampling system or around the ET tube
CO2 measurement techniques
• Various configurations and measurement techniques are currently available in devicesthat measure CO2, some of them are:
• Infrared (IR) absorption • Colorimetric detectors• mass spectrometry• Raman scattering• gas chromatography
Infrared (IR) absorption• has endured and evolved in the clinical setting for
more than two decades• the most popular and versatile technique today• Principle• is based on the fact that CO2 molecules absorb
infrared light energy of specific wavelengths• the amount of energy absorbed being directly
related to the CO2 concentration
• when an IR light beam is passed through a gas sample containing CO2, the electronic signal from a photodetector can be obtained• this signal is then compared to the energy of the IR
source, and calibrated to accurately reflect CO2 concentration in the sample• to calibrate, the photodetector’s response to a
known concentration of CO2 is stored in the monitor’s memory
Solid State vs. Chopper Wheel
• since the intensity of the IR light source must be known for a CO2 measurement to be made, some method must be employed to obtain a signal which makes that correlation• this can be done with or without moving parts
Solid state CO2 sensorsCO2 sensors that are not solid state
Solid state CO2 sensors• use a beam splitter to simultaneously measure the
IR light at two wavelengths: one that is absorbed by CO2 (data) and one that is not (reference)• also, the IR light source is electronically pulsed in
order to eliminate effects of changes in electronic components• the major advantage of solid state electronics is
durability
CO2 sensors that are not solid state
• employ a spinning disk known as a chopper wheel, which can periodically switch among the following to be measured by the photodetector:− The gas sample to be measured (data)− The sample plus a sealed gas cell with a known
CO2 concentration (reference)− No light at all• due to the moving parts, this type of arrangement
tends to be fragile
Mainstream vs. Sidestream sampling
• Mainstream and sidestream sampling refer to the two basic configurations of CO2 monitors,regarding the position of the actual measurement device relative to the source of the gas being sampled
Mainstream samplingSidestream sampling
Mainstream• mainstream CO2 sensors allow the inspired and
expired gas to pass directly across the IR light path• state-of-the-art technology allows this configuration
to be durable, small, lightweight and virtually hasslefree• the major advantages of mainstream sensors are
fast response time and elimination of water traps
Mainstream
Sidestream• are located away from the airway, requiring the gas
sample to be continuously aspirated from the breathing circuit and transported to the sensor by means of a pump
Sidestream
Colorimetric CO2 Detectors• Principle- Colorimetric CO2 detectors rely on a
modified form of litmus paper, which changescolor relative to the hydrogen ion concentration (pH) present• it actually measures the pH of the carbonic acid
that is formed as a product of the reaction between carbon dioxide and water (present as vapor in exhaled breath)
• exhaled and inhaled gas is allowed to pass across the surface of the paper and the clinician can then match the color to the color ranges printed on the device• it is usually recommended
to wait six breaths before making a determination
Value of the Capnogram • is an extremely valuable clinical tool that can be used
in many applications, including, but by no means limited to:¬ Validation of reported end-tidal CO2 value¬ Assessment of patient airway integrity¬ Assessment of ventilator, breathing circuit and gas
sampling integrity¬ Verification of proper endotracheal tube placement
Capnography examples andInterpretations
THANK YOU!!!