8/9/2019 CCAN 3 v5

http://slidepdf.com/reader/full/ccan-3-v5 1/2

How can an enterprise network be designed to optimize bandwidth? by organizingthe network to control traffic patterns

Which statement describes a characteristic of Cisco Meraki switches? They arecloud-managed access switches that enable virtual stacking of switches.

Which statement describes a characteristic of Cisco Catalyst 2960 switches? NewCisco Catalyst 2960-C switches support PoE pass-through.

What are two functions of a router? (Choose two.) It determines the best path tosend packets.

It connects multiple IP networks.

Which technology is required when switched networks are designed to includeredundant links? Spanning Tree Protocol

What is a characteristic of in-band device management? It is used to monitor andmake configuration changes to a network device over a network connection.

In which situation would a network administrator install a Cisco Nexus Series or CiscoCatalyst 6500 Series switch to promote infrastructure scalability? on a data centernetwork to provide expansion and transport flexibility

A network engineer is reviewing a network design that uses a fixed configurationenterprise router that supports both LAN and WAN connections. However, theengineer realizes that the router does not have enough interfaces to support growthand network expansion. Which type of device should be used as a replacement? amodular router

Immediately after a router completes its boot sequence, the network administratorwants to check the routers configuration. From privileged EXEC mode, which of thefollowing commands can the administrator use for this purpose? (Choose two.)

show startup-config show running-config

Refer to the exhibit. Which devices exist in the failure domain when switch S3 losespower? PC_3 and AP_2

8/9/2019 CCAN 3 v5

http://slidepdf.com/reader/full/ccan-3-v5 2/2

A network administrator is planning redundant devices and cabling in a switchednetwork to support high availability. Which benefit will implementing the Spanning TreeProtocol provide to this design? Redundant paths can be available without causinglogical Layer 2 loops.

Why would a network administrator issue the show cdp neigbors command on arouter? to display device ID and other information about directly connectedCisco devices

Which two requirements must always be met to use in-band management to configurea network device? (Choose two.) at least one network interface that is connectedand operational

Telnet, SSH, or HTTP access to the device

What are two benefits of extending access layer connectivity to users through awireless medium? (Choose two.) reduced costs, increased flexibility.

As the network administrator you have been asked to implement EtherChannel on thecorporate network. What does this configuration consist of? grouping multiplephysical ports to increase bandwidth between two switches

Which two features of enterprise class equipment assists an enterprise network inmaintaining 99.999 percent up-time? (Choose two.) redundant power supplies, failover capabilities

Which design feature will limit the size of a failure domain in an enterprise network?the use of the building switch block approach