12
Changing Brushes on Standard Style Motors
Changing Brushes on
Standard Style Motors
The FIRST step is to ...
Unplug the motor!
…with the lead still connected to brush.
Do NOT remove the clamps freeing the brush mechs from the bracket….
Removing Brush Clip terminal from Mech
Removing Brush Clip terminal from Mech
Removing Brush Clip terminal from Mech
Installing new brush mech.
Slide brush clip between Nylon and Brass
Make certain positioning tab is placed in slot.
Install brush clamp screws
Seat the brushes by opertaing at half voltage for 20-30 minutes. Use two motors in electrical SERIES; 60 volts dropped across each motor.
Ideal Industries – Cat No. 23-001H Brush Seater and Commutator Cleaner
www.idealindustries.com
