+ All Categories
Home > Documents > Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Date post: 29-Jan-2016
Category:
Upload: dinah-armstrong
View: 356 times
Download: 4 times
Share this document with a friend
Popular Tags:
36
Chapter 8 Acid-Base Titrations (Neutralization Titrations
Transcript
Page 1: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Chapter 8

Acid-Base Titrations

(Neutralization Titrations

Page 2: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Titrations Curves for Strong Acids and Strong Bases.

• Strong acids and strong bases ionize with 100% efficiency in aqueous solution.  

• HA  + H2O ----> H3O+  +  A-

• MOH  ---->  M+  +  OH-

• The net reaction of strong acids with strong bases is the reaction of a hydronium ion with a hydroxide ion to form water.  

H3O+  +  OH- ----> H2O• Titration curves of strong acids with strong bases are divided

into domains:1. Before equivalence. 2. At equivalence. 3. After equivalence.

Page 3: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Before equivalence: 1. Initially, before any base is added to the acid sample, the [H3O

+]total = CHA  +  [H3O+]water.

2. If the CHA is greater than 10-6 M, the [H3O+]water can

be ignored.

3. As strong base is added but prior to equivalence, [H3O

+] is consumed. The remaining [H3O+] is

calculated as follows 

                                                                 

Page 4: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

At equivalence point

• The acid and base have reacted at the stoichiometric ratio.

2. The [H3O+]  =  [OH-]  =                    M

3. The pH = 7 at equivalence.

Page 5: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Beyond equivalence:

1. All the acid is consumed; only base is present. 2. The amount of base is calculated from the excess added beyond equivalence.

                                                                 

Page 6: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• Note that:• If CAcid is greater than 10-6 M, we have

assumed that the water contribution to the hydronium ion concentration can be ignored.

• If CAcid is less than 10-8 M, you can also assume that the water is primarily responsible for the hydronium ion concentration, and that the added acid is insignificant.

• Only when the CAcid is between 10-8 - 10-6 M must the water contribution to the hydronium ion concentration be considered.

Page 7: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Strong Acid and Strong Base

• The following figure shows the titration of a strong acid with 0.100 M NaOH.

• For titration of a strong acid with a strong base, the equivalence point occurs at a pH of 7.

Page 8: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• We can identify three different regions in this titration experiment.

• Before the equivalence point the pH is determined by the concentration of unneutralized strong acid.

• At the equivalence point the pH, 7, is determined by the dissociation of water.

• After the equivalence point the pH is determined by the concentration of excess strong base that we are adding.

Page 9: Chapter 8 Acid-Base Titrations (Neutralization Titrations.
Page 10: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• Acid-base indicators (pH indicators) are weak organic acids or weak organic bases that change color as a function of ionization state. • Acid-base indicators of two types have different ionization equilibria: 1. Acid-type indicators:

                                                    

2. Base-type indicators:                                       

Detection of the end-point: Acid-Base Indicators

• As the pH changes, each equilibrium above shifts in response, producing a color change.

Page 11: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• Human visual only responds to dramatic color changes. Changes of less than 10% usually are not visible,

• Thus, the molar concentrations of the indicator species must constitute approximately 90% of the indicator before the color changes are seen clearly.

– To see the In- color: -To see the HIn color:

][

][log

Inin H

InpKpH

]10[

]1[log inpKpH

1 inpKpH Only the color of unionized form is seen

][

][log

In

HpKpH In

in]1[

]10[log inpKpH

1 inpKpH Only the color of ionized form is seen

Page 12: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

– Acid-base indicators (like any ionizable molecule) are 50% ionized at the pKa

– At 1 pH unit above the pKa, 90% of the ionizable indicator is in its basic form.

– At 1 pH unit below the pKa, 90% of the ionizable indicator is in its acid form.

– Thus, indicators show a full color transition +/- 1 pH unit of the pKa, and indicators are generally selected based upon the closeness of their pKa to the endpoint pH.

• Most indicators require a transition range of about 2 pH units

• During the transition the observed color is a mixture of the two colors

• Midway of the transition the concnetration of the two forms are equal

• pka of indicator should be close to the pH of the equivalence point

Page 13: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Variable affecting acid-base indicator behavior include• Ionic strength (changes Ka, shifts equilibrium).

• Temperature. • Solvent and solvent polarity (especially organic solvents which

may shift color transitions several pH units). • Colloidal particulates may interfere through surface adsorption

of the indicator

• If concentrations of acid and base are 0.1 M or higher, it doesn't make much difference. The large endpoint transition spans the color transition range of almost all indicators.• If concentrations drop significantly below 0.1 M, an indicator whose pKa is as close as possible to pH 7.0 +/- 1 is best. • If concentrations of acid and base drop too low, (i.e., the endpoint transition spans less than two pH units), no indicator will work very well.

Choosing acid-base indicators for strong acid-strong base titration

Page 14: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Acid base indicators

• In an acid-base titration, addition of titrant near the equivalence point causes the solution pH to change drastically.

• This pH change is detectable with indicators that change color as a function of pH.

• Indicators are weak acids that change color when they gain or lose their acidic proton(s).

Page 15: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• The table lists a few common indicators with the color of their acidic and basic forms and the pH range over which the color change occurs. (The listed endpoint color assumes titration of an acid with base, i.e., increasing pH.)

Page 16: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Color

pH RangeIndicator

  acidic endpoint basic  

bromocresol green yellow green blue 4.0-5.6

methyl red red yellow yellow 4.4-6.2

bromothymol blue yellow green blue 6.2-7.6

phenolpthalein colorless light pink red 8.0-10

Page 17: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

Titration Curves for Weak Acids Titrated with a Strong Base

• Acetic Acid Titrated with NaOH • Acetic acid is a monoprotic acid (pKa =

4.757).• NaOH is a monohydroxy, strong base. • Titration of acetic acid with NaOH follows a

curve similar in shape to the strong acid-strong base titration curve, but the equivalence point is not a pH 7.

• Shown below is a titration curve for 0.100 M acetic acid titrated with 0.100 M NaOH.

Page 18: Chapter 8 Acid-Base Titrations (Neutralization Titrations.
Page 19: Chapter 8 Acid-Base Titrations (Neutralization Titrations.
Page 20: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• During the titration and in the generation of a titration curve, four regions will be considered: – No NaOH added (i.e., 0.100 F acetic acid).– NaOH added, but before equivalence has

been reached. – At the equivalence point (i.e., 0.100 F

acetate ion). – After equivalence.

Page 21: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

TITRATION OF A WEAK ACID WITH A STRONG BASETITRATION OF A WEAK ACID WITH A STRONG BASE

Page 22: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

1. No NaOH added

• [H3O+] is calculated from the Ka of acetic acid.

 

• If X is not << CHAc, the quadratic formula must be used to solve for X.

Page 23: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

2. NaOH added, but before equivalence

• Added NaOH reacts with HAc producing a buffer (a mixture of HAc and Ac-).

• The concentrations of HAc and Ac are calculated from the volumes reacted and substituted into the Ka (or Henderson-

Hasselbalch equation) to calculate [H3O+] and pH.

Page 24: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• In using these equations, check the assumptions made that allow use of Ka or the Henderson-Hasselbalch. They are: – Water equilibrium contributions are negligible.

– CNaAc and CHAc >> [H3O+] and [OH-]

• If the assumptions do not check, use the Charlot equation.

Page 25: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

3. At equivalence point

• At equivalence point, the HAc and NaOH have reacted at the stoichiometric ratio. # moles HAc initially present = # moles NaOH added

• The solution at the equivalence point is identical to dissolving sodium acetate (NaAc) in water. The [H3O+] may be calculated from the base hydrolysis of Ac-.

• Note that X is assumed to be << CNaAc. This assumption must be checked.• If the assumption is not true, the quadratic formula must be used to solve for X.

Page 26: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

4. Beyond equivalence

• Beyond equivalence, all the HAc is consumed and the presence of excess OH- prevents the base hydrolysis of of the Ac-.

• The concentration of the excess OH- is calculated from the reacted volumes and used to calculate

[H3O+] and pH.

Page 27: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

General characteristics of weak acid titrations with strong bases

• If the concentrations of acid are too low, you cannot ignore the water contributions to [H3O+] and [OH-].

• Low acid concentrations decrease the magnitude of the pH change at the equivalence point, limiting the selection of endpoint indicator. Conversely, the higher the acid concentrations, the larger the pH change around the equivalence point.

• As Ka gets smaller, the pH change at equivalence gets smaller. Generally, the smaller Ka gets, the more concentrated the solutions must be. Acids with Ka below 10-6-10-7 M are nearly impossible to titrate easily with a buret and typically endpoint indicator.

Page 28: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• Titrations of weak bases with strong acids are "mirror images" of the weak acid titrations already discusses. • Shown below is a typical titration curve:                                             

Titration Curves for Weak Bases Titrated with a Strong Acid.

Page 29: Chapter 8 Acid-Base Titrations (Neutralization Titrations.
Page 30: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• For the sake of discussion, assume cyanide ion, CN- from NaCN, is being titrated with HCl.

• The titration curve is divided into regions similar to the acid titrations: – No HCl added. – HCl added, but before equivalence. – At equivalence. – After equivalence.

Page 31: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• Where is the equivalence point?Where is the equivalence point?

TITRATION OF A WEAK BASE WITH A STRONG ACIDTITRATION OF A WEAK BASE WITH A STRONG ACID

Page 32: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

1. No HCl added region

• [OH-] is calculated from the Kb expression.  

• Once [OH-] is calculated, [H3O+] and pH is calculated

Page 33: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

2. HCl added, but before the equivalence point • The solution is a buffer consisting of HCN and CN-. • The concentration of each species is calculated from the

added volumes and substituted into the Henderson-Hasselbalch equation (or Ka for HCN).

• Note, again, that assumptions are made about ignoring water's contributions to [OH-] and [H3O+]. These assumptions must be checked.

• Also, it is assumed that [OH-] and [H3O+] are << CNaCN and CHCN. This also must be checked.

Page 34: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

• All the CN- has been converted to HCN. The solution is the same as an HCN solution.                                       

• Note, the same sets of assumptions to be checked.

3. At the equivalence point:

Page 35: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

4. After the equivalence point

• The pH is determined by the amount of acid added in excess to the amount of CN- initially present.

• Note, yet again, the same sets of assumptions to be

checked.

Page 36: Chapter 8 Acid-Base Titrations (Neutralization Titrations.

                                                                           <

TARGET="display">


Recommended