Cherry Bomb Quick-Start Hookup

Step 1

Your wire whips look like this out of the box. All we need for 8Ω wiring are the

GREEN and WHITE wires.

Cut the GREEN, RED, BLACK, and WHITE wires loose from the wire nuts.

Separate wires. Cap off the RED and BLACK wires, as they are not needed unless you require

70V functionality.

Step 2

Step 3 Step 4

(For use in 8Ω mode)

Step 7

Cap off the BLUE and YELLOW wires, as they are not needed unless you re-

quire 70V functionality.

Plug wires into your amplifier.

Step 8

Strip the insulation roughly 1/4” from the GREEN and WHITE wires. The

GREEN (+) wire is your positive, while WHITE (-) is negative.

Wire your positive and negative leads according to your amplifier channel configuration. Here we are using the

OS-440.

Step 5 Step 6

Rock out.

Step 9

For further support and assistance, contact techsupport@mseaudio.com

Rockustics® by MSE Audio® | 10661 Rene St. | Lenexa, KS 66215

913-663-5600 or 855-663-5600 | www.rockustics.com Rev 7.09.2019