Check N/A * Check N/A Check N/A 4. Life Safety Plans. 5. Occupant load calculations. Six (6) sets of plans are required to be submitted for plan review If value of construction exceeds $50,000.00 plans will also be required in digital format in addition to the six (6) paper sets. 2. The following information shall be shown on the plans (if not applicable, mark N/A). 3. Properly sealed in accordance with design professional requirements. 1. Must include plans for all disciplines indicated on the permit application. I understand that if there are unsatisfied parcel conditions that are brought to my attention during the plan review, it will be my responsibility to address those conditions with the department(s) having 14. Plumbing fixture requirements. 16. Electrical summary. C. Building plans shall include, but not limited to the following criteria: B. General Code Data 17. Mechanical summary. 3. Code edition. 4. Building data. 5. Project Summary 6. Building Description 7. Scope of Work 8. Allowable area. 10. Fire protection requirements. 11. Life safety system requirements. 12. Life safety plan requirements. 13. Accessibility. 9. Allowable height. 1. Name of project and address /location information. 2. Design professional information. CITY OF MUSTANG COMMUNITY DEVELOPMENT DEPARTMENT 1501 N. MUSTANG RD, MUSTANG, OKLAHOMA, 73064 COMMERCIAL PLAN REVIEW CHECKLIST This checklist is required to accompany all commercial building permit applications. TO BE COMPLETED BY APPLICANT Address from Building Permit Application_______________________________________________ A. Application Requirements Special inspections schedule. There should be no discrepancy between the building permit application's job description and scope of work depicted on the plans. Approved site plan, or written verification that no site plan is required. * Items marked with an asterisk, are required for submittal. Failure to provide these documents will result in rejection Complete Item B (General Code Data). Complete means no line left unaddressed or TBD. Incomplete information cannot be submitted for review. * Complete and signed building permit application. Complete means no line left unaddressed or TBD. Applications without addresses and/or correct suite numbers, or recorded plat information cannot be submitted for review. Construction plans are signed, sealed and dated by a registered and licensed design professional for new construction, alteration, relocation, enlargement, replacement, and renovation of any structure 1500 square foot or larger in area. NO HAND DRAWN PLANS WILL BE ACCEPTED "Draft" or "Not for Construction" notes have been removed.
Transcript
Check N/A
*
Check N/A
Check N/A
4. Life Safety Plans.
5. Occupant load calculations.
Six (6) sets of plans are required to be submitted for plan review
If value of construction exceeds $50,000.00 plans will also be required in digital format in addition to
the six (6) paper sets.
2. The following information shall be shown on the plans (if not applicable, mark N/A).
3. Properly sealed in accordance with design professional requirements.
1. Must include plans for all disciplines indicated on the permit application.
I understand that if there are unsatisfied parcel conditions that are brought to my attention during the
plan review, it will be my responsibility to address those conditions with the department(s) having
14. Plumbing fixture requirements.
16. Electrical summary.
C. Building plans shall include, but not limited to the following criteria:
B. General Code Data
17. Mechanical summary.
3. Code edition.
4. Building data.
5. Project Summary
6. Building Description
7. Scope of Work
8. Allowable area.
10. Fire protection requirements.
11. Life safety system requirements.
12. Life safety plan requirements.
13. Accessibility.
9. Allowable height.
1. Name of project and address /location information.
2. Design professional information.
CITY OF MUSTANG COMMUNITY DEVELOPMENT DEPARTMENT
1501 N. MUSTANG RD, MUSTANG, OKLAHOMA, 73064
COMMERCIAL PLAN REVIEW CHECKLIST
This checklist is required to accompany all commercial building permit applications.
TO BE COMPLETED BY APPLICANT
Address from Building Permit Application_______________________________________________
A. Application Requirements
Special inspections schedule.
There should be no discrepancy between the building permit application's job description and scope of
work depicted on the plans.
Approved site plan, or written verification that no site plan is required.
*
Items marked with an asterisk, are required for submittal. Failure to provide these documents will result in rejection
Complete Item B (General Code Data). Complete means no line left unaddressed or TBD.
Incomplete information cannot be submitted for review.
* Complete and signed building permit application. Complete means no line left
unaddressed or TBD. Applications without addresses and/or correct suite numbers, or
recorded plat information cannot be submitted for review.
Construction plans are signed, sealed and dated by a registered and licensed design professional for
new construction, alteration, relocation, enlargement, replacement, and renovation of any structure
1500 square foot or larger in area. NO HAND DRAWN PLANS WILL BE ACCEPTED
"Draft" or "Not for Construction" notes have been removed.
Check N/A
Check N/A
Check N/A
Check N/A
Check N/A
TO BE COMPLETED BY APPLICANT (CONTINUED)
Signature Date
8. Gas piping diagrams on mechanical plans.
It is acknowledged by placing a mark in the above requirements, and my signature below, that: I have verified that all applicable
information is included in the construction plans and application. Furthermore, I understand that any omissions will result in
disapproval of this application. It is also acknowledged there may be a re-review fee for omissions resulting in disapproval of
initialed requirements for this application.
Name
2. Dryer vent length schedule when applicable.
3. Fire dampers/proper protection for rated assembly penetrations clearly delineated.
4. Clearly list rated assemblies on plans.
5. Outside air calculations included on plans.
6. Correct UL assembly and details on plans.
7. Detailed plans for Type one hoods and related duct work if applicable.
8. Grease trap specifications and details.
G. Mechanical1. Design professional sealed in accordance with state law.
2. Fixture count calculations based on occupant load.
3. Toilet stall dimensions, length and width.
4. Isometric riser/venting diagram.
5. Vents on floor drains
6. Show clear floor spaces for all plumbing fixtures (accessibility code).
7. Show fixture elevations with height and width dimensions (accessibility code).
F. Plumbing1. Design professional sealed in accordance with state law.
5. For PV installations include a three line diagram and specification sheets for new equipment
4. Panel schedules/load calculations.
3. One line diagram of the service/feeder riser.
2. Complete plans for proposed work and any demolition of existing electrical.
1. Design professional sealed in accordance with state law.
E. Electrical
7. Number of exits with corresponding building/space diagonal distance and distance between exits.
8. Common path of egress travel distances.
9. Corridor widths.
10. Dead end corridor dimensions.
11. Special locking arrangements/ Panic hardware detailed where applicable.
12. Stair and other shaft ratings.
C. Building plans shall include, but not limited to the following criteria:6. Exit access travel distance (Exits through adjoining spaces where allowed by code, shall be clearly
6. Elevator details.
7. Accessible counters height and width.
8. Area of refuge/area for assisted rescue details.
1. Accessibility to and through building/facility’s common areas.
