© 2015 Thermaltake Technology Co., Ltd. All Rights Reserved. www.thermaltake.com
This product is intended for installation only by expert users. Please consult with a qualified technician for
installation. Improper installation may result in damage to your equipment.
1. Please carefully read the manual before beginning the installation process !
2. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000.
3. DO NOT USE any kind of alcohol or alcohol derivatives with this reservoir or the acrylic tube may crack
and fail ! Do not clean it using alcohol either !
Pacific
PR2U
Pacific PR2U Pump + Reservoir
Installation Guide
Parts List
Screw G1/4 Stop Plug WrenchPressure Equalizer Plug
Pump + Reservoir
A x 1
B x 8 C x 2 D x 1 E x 1 F x 1
Caution
1. Do not soak the pressure equalizer plug in
water / coolant
2. Please drain your loop and seal the fill port
with stop plug before transporting your PC
A
D
C
E
F
Pressure equalizer plug
G1/4 Stop Plug
Stop Plug
Wrench
Pump + Reservoir
G1/4 Stop Plug
Place the Pacific PR2U in your
5.25" drive bay with the front
plate facing outwards. Secure
the reservoir to the drive bay
cage using the enclosed M3
screws(B) x 8.
1 2
Use any two of G1/4 threaded ports on the
back of reservoir as an outlet or inlet port.
3
Fill the reservoir through
G1/4 threaded fill ports.
Thermaltake recommends
to install the pressure
equalizer plug on the top of
the reservoir allowing air
and pressure to
automatically pass through
the plug preventing
pressure buildup in your
loop.
Pump + Reservoir
HIGH
LOW
Outlet G1/4 port
Inlet G1/4 port
Fill port
Fill port
HIGH
LOW