+ All Categories
Home > Documents > CL800 2V 800Ah(10hr) - Vision BattShenzhen Center Power Tech.Co.Ltd,. Shenzhen Center Power...

CL800 2V 800Ah(10hr) - Vision BattShenzhen Center Power Tech.Co.Ltd,. Shenzhen Center Power...

Date post: 29-Mar-2020
Category:
Upload: others
View: 2 times
Download: 0 times
Share this document with a friend
2
Shenzhen Center Power Tech.Co.Ltd,. www.vision-batt.com Shenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733 (Note)The above characteristics data are average values obtained within three charge/discharge cycles not the mimimum values.All data shall be changed without notice,Vision reserves the right to explain and update the information contained hereinto. Overview Battery Specification The rechargeable batteries are ead- ead dioxide systems. The di ute su furic acid e ectro yte is absorbed by separators and plates and thus immobilized. Should the battery be accidentally overcharged producing hydrogen and oxygen, special oneway valves allow the gases to escape thus avoiding excessive pressure build-up. Otherwise, the battery is completely sealed and is, therefore, maintenance-free, leak proof and usable in any position. l l l l l l * Weight deviation: ± 3% Performance Characteristics Battery Construction Positive plate Negative plate Container Cover Safety valve Terminal Separator Electrolyte Raw material Lead dioxide Lead ABS ABS Rubber Copper Fiberglass Component Sulfuric acid Absorbent Glass Mat (AGM) technology for efficient gas recombination of up to 99% and freedom from electrolyte maintenance or water adding. Not restricted for air transport-complies with IATA/ICAO Special Provision A67. UL-recognized component. Can be mounted in any orientation. Computer designed lead, calcium tin alloy grid for high power density. Long service life, float or cyclic applications. Maintenance-free operation. Low self discharge. Case and cover available in both standard and flame retardant ABS. General Features Dimensions and Weight End Point Volts/Cell 15min 30min 45min 1h 3h 5h 10h End Point Volts/Cell 15min 30min 45min 1h 2h 3h 5h Nominal Voltage Number of cell Design Life Nominal Capacity 77℉(25℃) Internal Resistance Self-Discharge Operating Temperature Range Max. Discharge Current 77℉(25℃) Charge Methods: Constant Voltage Charge 77℉(25℃) 2V 1 20 years 10 hour rate (80.0A, 1.8V) 800Ah 5 hour rate (144A, 1.75V) 720Ah 1 hour rate (496A, 1.6V) 496Ah Fully Charged battery 77 (25℃) ≤0.7 mOhms 3% of capacity declined per month at 20℃(average) Discharge -20~60℃ Charge -10~60℃ Storage -20~60℃ 3000A(5s) Cycle use 2.40-2.45VPC Maximum charging current 160A Temperature compensation -5.0mV/℃ Standby use 2.20-2.30VPC Temperature compensation -3.3mV/℃ o Discharge Constant Current (Amperes at 77 F25 C) o Discharge Constant Power (Watts at 77 F25 ) o o C CL800 2V 800Ah(10hr) Length(mm / inch) 410/16.14 Width(mm / inch) 175/6.98 Height(mm / inch) 330/13.0 Total Height(mm / inch) 367/14.5 Approx. Weight(Kg / lbs) 57/125.7 367 1.60V 1281 830 650 496 227 156 86.0 1.65V 1219 793 624 478 220 152 84.9 1.70V 1156 755 597 458 213 148 83.0 1.75V 1091 716 568 439 204 144 81.8 1.80V 1025 676 538 418 195 139 80.0 1.60V 1995 1497 1133 936 632 451 303 1.65V 1887 1422 1081 896 613 432 298 1.70V 1777 1346 1027 855 594 413 292 1.75V 1667 1267 971 812 575 394 286 1.80V 1557 1189 915 769 556 375 271
Transcript
Page 1: CL800 2V 800Ah(10hr) - Vision BattShenzhen Center Power Tech.Co.Ltd,. Shenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733 2V 800Ah(10hr)Self-discharge characteristic 100 90 80 70

Shenzhen Center Power

Tech.Co.Ltd,.

www.vision-batt.comShenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733

(Note)The above characteristics data are average values

obtained within three charge/discharge cycles not the mimimum

values.All data shall be changed without notice,Vision reserves

the right to explain and update the information contained

hereinto.

Overview

Battery Specification

The rechargeable batteries are ead- ead dioxide systems. The di ute su furic acid e ectro yte is

absorbed by separators and plates and thus immobilized. Should the battery be accidentally

overcharged producing hydrogen and oxygen, special oneway valves allow the gases to escape

thus avoiding excessive pressure build-up. Otherwise, the battery is completely sealed and is,

therefore, maintenance-free, leak proof and usable in any position.

l l l l l l

* Weight deviation: ± 3%

Performance Characteristics

Battery Construction Positive plate Negative plate Container Cover Safety valve Terminal Separator Electrolyte

Raw material Lead dioxide Lead ABS ABS Rubber Copper Fiberglass

Component

Sulfuric acid

Absorbent Glass Mat (AGM) technology for efficient gas

recombination of up to 99% and freedom from

electrolyte maintenance or water adding.

Not restricted for air transport-complies with IATA/ICAO

Special Provision A67.

UL-recognized component.

Can be mounted in any orientation.

Computer designed lead, calcium tin alloy grid for high

power density.

Long service life, float or cyclic

applications.

Maintenance-free operation.

Low self discharge.

Case and cover available in both standard and flame

retardant ABS.

General Features

Dimensions and Weight

End Point

Volts/Cell 15min 30min 45min 1h 3h 5h 10h

End Point

Volts/Cell 15min 30min 45min 1h 2h 3h 5h

Nominal Voltage

Number of cell

Design Life

Nominal Capacity 77℉(25℃)

Internal Resistance

Self-Discharge

Operating Temperature Range

Max. Discharge Current 77℉(25℃)

Charge Methods: Constant Voltage Charge 77℉(25℃)

2V

1

20 years

10 hour rate (80.0A, 1.8V) 800Ah

5 hour rate (144A, 1.75V) 720Ah

1 hour rate (496A, 1.6V) 496Ah

Fully Charged battery 77 (25℃) ≤0.7 mOhms

3% of capacity declined per month at 20℃(average)

Discharge -20~60℃

Charge -10~60℃

Storage -20~60℃

3000A(5s)

Cycle use 2.40-2.45VPC

Maximum charging current 160A

Temperature compensation -5.0mV/℃

Standby use 2.20-2.30VPC

Temperature compensation -3.3mV/℃

oDischarge Constant Current (Amperes at 77 F25 C)o

Discharge Constant Power (Watts at 77 F25 )o oC

CL800 2V 800Ah(10hr)

Length(mm / inch) 410/16.14

Width(mm / inch) 175/6.98

Height(mm / inch) 330/13.0

Total Height(mm / inch) 367/14.5

Approx. Weight(Kg / lbs) 57/125.7

367

1.60V 1281 830 650 496 227 156 86.0

1.65V 1219 793 624 478 220 152 84.9

1.70V 1156 755 597 458 213 148 83.0

1.75V 1091 716 568 439 204 144 81.8

1.80V 1025 676 538 418 195 139 80.0

1.60V 1995 1497 1133 936 632 451 303

1.65V 1887 1422 1081 896 613 432 298

1.70V 1777 1346 1027 855 594 413 292

1.75V 1667 1267 971 812 575 394 286

1.80V 1557 1189 915 769 556 375 271

Page 2: CL800 2V 800Ah(10hr) - Vision BattShenzhen Center Power Tech.Co.Ltd,. Shenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733 2V 800Ah(10hr)Self-discharge characteristic 100 90 80 70

Shenzhen Center Power

Tech.Co.Ltd,.

www.vision-batt.comShenzhen Center Power Tech.Co.Ltd,. STOCK CODE: 002733

CL800 2V 800Ah(10hr)

Self-discharge characteristic

100

90

80

70

60

50

400 2 4 6 8 10 12 14 16 18 20

Storage time: months

Life characteristics of standby use

Ca

pa

city

(%)

120

100

80

60

40

20

00 5 10 15

Life(year)

Testing conditions: floating voltage: 2.25 to 2.30V/Celll

oo ambient temperature: 25 ℃(77 F)

Cycle service life in relation to depth of discharge

Number of cycles(cycles)

Ca

pa

city

(%)

120

100

80

60

40

20

0 400 800 1200 1600 2000 2400

100% D.O.D. 50% D.O.D. 30% Depth of discharge

Temperature effects on float life

20

10

5

010 20 30 40 50

2.30V/Cell

ODischarge characteristic (25 C)

min h

Discharge time

Volta

ge

(V)

2.0

1.6

01 2 3 5 10 20 30 60 2 3 5 10 20

1600A 800A

80A204A 144A

496A

Relationship between charging voltage and temperature

-10Ambient temperature( ℃)

2.6

2.5

2.4

2.3

2.2

ST ND Y SEA B U

CLE E

CYUS

Vo

ltag

e (

V)

Temperature effects on capacity120

100

80

60

40

20

0-20 -10 0 10 20 30 40 50

Temperature( ℃)

20. C

0.3C

1.0C

01C.

2.0C

Charging characteristic for standby use

40 8 12 16 20 24

2.20

2.40

2.00

1.80

1.60

1.40

0.14

0.17

0.11

0.08

0.05

0.02

100

120

80

60

40

20

)Ratio

Battery Voltage

Discharge

100%(0.1CAx10H)---- 50%(0.1CAx5H)

Charge

Charge Voltage(2.25V/Cell)

Charge Current 0.1CATemperature2 5

lle

C re

P/)V(

eg

atlo

V

)A

C(tn

erru

C e

gra

hCC

ha

rge

d

Vo

lum

e(%

)

)

Charging time (hours)

Temperature (℃)

Lif

e(y

ears

)

40℃ 30℃ 20℃


Recommended