Clean Air BoxesClean Air Boxes

CABs

RAMs

CO Monitors

Features at a GlanceFeatures at a Glance

Grade D ComplianceGrade D Compliance Auto CalibrationAuto Calibration Warning SystemsWarning Systems Triple Power Source OptionsTriple Power Source Options Durable ConstructionDurable Construction Independent RegulatorsIndependent Regulators

Grade D ComplianceGrade D Compliance

• Set by Compressed Gas AssociationSet by Compressed Gas Association• OSHA 1910.134 References NIOSH OSHA 1910.134 References NIOSH

42CFR84.141(b)42CFR84.141(b)• Oxygen 19.5%-23.5%Oxygen 19.5%-23.5%• Hydrocarbons or oil (condensed) Hydrocarbons or oil (condensed)

5mg/m5mg/m33 max. max.• Carbon Monoxide (C0) 10 ppm maxCarbon Monoxide (C0) 10 ppm max• Carbon Dioxide (COCarbon Dioxide (CO22) 1,000 ppm max) 1,000 ppm max• Odor – no noticeable taste or smellOdor – no noticeable taste or smell• No toxic contaminants at levels that No toxic contaminants at levels that

make the air unsafe to breathemake the air unsafe to breathe

Grade D ComplianceGrade D Compliance

Incoming air with 19.5-23.5% Oxygen

5 micron particulate filtration

.01 Micron Filtration

Carbon filtration for tastes

and smells

Carbon Monoxide

Monitor for 10 ppm

max.

*3 stage filtration is only one element of an OSHA compliant Grade D breathing air system. The *3 stage filtration is only one element of an OSHA compliant Grade D breathing air system. The incoming air should be tested prior to use. CAB Series products will not remove CO, COincoming air should be tested prior to use. CAB Series products will not remove CO, CO22, ,

Nitrogen or other toxic gases or fumes. These units will not increase oxygen supply and should Nitrogen or other toxic gases or fumes. These units will not increase oxygen supply and should not be used when air entering the system is oxygen deficient. not be used when air entering the system is oxygen deficient.

Auto CalibrationAuto Calibration

90 Seconds90 Seconds No tools requiredNo tools required No flow meter to adjustNo flow meter to adjust No potentiometer to adjustNo potentiometer to adjust Easy: push a single buttonEasy: push a single button

*It is recommended that the unit be zeroed with impurity free *It is recommended that the unit be zeroed with impurity free test gas before calibration.test gas before calibration.

Warning SystemsWarning Systems

CO alarmCO alarm• Visual and audibleVisual and audible

Low flow alarmLow flow alarm Remote alarm Remote alarm

• 90dB with strobe90dB with strobe Low battery alarmLow battery alarm

• Visual and audibleVisual and audible Filter change Filter change

indicatorsindicators

Triple Power Source OptionsTriple Power Source Options

110V AC

U.S. power cord std.

Int’l cords available

9V battery in CO monitor

80 hrs of operation on (8) AA batteries make unit totally self-contained

Durable ConstructionDurable ConstructionPolycarbonate Pelican brand

cases

Powder coated steel

Automatic condensate

drains extend filter life

Long life LEDs for fewer

replacements

Working pressure range up to 150 psi

1 year limited

warranty on systems

2 year warranty

on CO sensors

Independent RegulatorsIndependent Regulators

Independent regulators allow up to 8 different workers to control their air supply properly

Remote Air ManifoldsRemote Air Manifolds

RAM Features at a GlanceRAM Features at a Glance

NIOSH complianceNIOSH compliance Available sizesAvailable sizes Available optionsAvailable options

Point of Attachment CompliancePoint of Attachment Compliance 42CFR Part 84 Subpart J .14942CFR Part 84 Subpart J .149

www.cdc.gov/niosh/pt84abs2.htmlwww.cdc.gov/niosh/pt84abs2.html Pressure gaugePressure gauge - allows verification of this - allows verification of this

pressure setting at the point of attachment (see pressure setting at the point of attachment (see 84.149 (b)).84.149 (b)).

RegulatorRegulator - allows adjustment of air pressure to - allows adjustment of air pressure to manufacturer’s specified pressure range based manufacturer’s specified pressure range based on range of hose length used (see 84.149 (b)).on range of hose length used (see 84.149 (b)).

Pressure relief valvePressure relief valve prevents pressure from prevents pressure from exceeding 125 psi (see 84149 (d) (1)).exceeding 125 psi (see 84149 (d) (1)).

Congruous fittingCongruous fitting allows connection of allows connection of “Detachable couplings” as part of NIOSH “Detachable couplings” as part of NIOSH approved respirator system (see 84.131 (5)).approved respirator system (see 84.131 (5)).

NIOSH ComplianceNIOSH Compliance

Regulator

Pressure gauge

125 psi pressure relief valve

Congruous fitting

Available Sizes & OptionsAvailable Sizes & Options

1, 2, 4, 8 Outlets1, 2, 4, 8 Outlets Independent Independent

regulators availableregulators available 5 outlet fitting types 5 outlet fitting types

availableavailable• HansenHansen• Hansen StainlessHansen Stainless• Snap TiteSnap Tite• SchraderSchrader• CEJNCEJN

CO MonitoringCO Monitoring

Features at a GlanceFeatures at a Glance

ComplianceCompliance Auto calibrationAuto calibration Durable constructionDurable construction 41 Series Filter bundles41 Series Filter bundles

ComplianceCompliance

*The COHP addresses the CO monitoring requirement for OSHA compliance of a *The COHP addresses the CO monitoring requirement for OSHA compliance of a Grade D breathing air system. Filtration must be addressed separately.Grade D breathing air system. Filtration must be addressed separately.

Meets OSHA Grade D

requirements for CO

monitoring and all NIOSH requirements for Point of Attachment

Auto CalibrationAuto Calibration

90 seconds90 seconds No tools requiredNo tools required No flow meter to adjustNo flow meter to adjust No potentiometer to adjustNo potentiometer to adjust Easy: push a single buttonEasy: push a single button

*It is recommended that the unit be zeroed with impurity free *It is recommended that the unit be zeroed with impurity free test gas before calibration.test gas before calibration.

Durable ConstructionDurable Construction

Polycarbonate Pelican brand

cases

Working pressure range up to 150 psi

1 year limited

warranty on system

2 year warranty

on CO sensor

41 Series Filter Bundles41 Series Filter BundlesThe popular 41 Series 7-stage

filtration systems from Bullard can be

bundled with a Bullard COHP

monitor to help comply with the key requirements for an

OSHA Grade D Breathing Air

System

*7 stage filtration and CO monitoring alone will not guarantee an OSHA compliant Grade D *7 stage filtration and CO monitoring alone will not guarantee an OSHA compliant Grade D breathing air system. The incoming air should be tested prior to use. Neither CAB Series nor 41 breathing air system. The incoming air should be tested prior to use. Neither CAB Series nor 41

Series products will not remove CO, CO Series products will not remove CO, CO22, Nitrogen or other toxic gases or fumes. These units , Nitrogen or other toxic gases or fumes. These units will not increase oxygen supply and should not be used when air entering the system is oxygen will not increase oxygen supply and should not be used when air entering the system is oxygen

deficient. deficient.

SupportSupport

Call 877-BullardCall 877-Bullard Visit Visit www.bullard.comwww.bullard.com